A4Tech RSW25 User Manual

Radio Wireless Wheel Mouse

User’s Guide

MODEL: RFSW-25

Trademark Recognition

Windows, Office 97 and MS-IntelliMouse are registered trademarks of Microsoft Corp.

MN-RFSW25-NC

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.

Federal Communications Commission Requirements

The equipment has been tested and found to comply with the limits for Class B Digital
Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction, may cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

l Reorient of relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

l Consult the dealer or an experienced radio/TV technician for help.
The changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

— 1 —

I

NNTTRROODDUUCCTTIIO

I

Congratulations on your purchase! Your new RF-Mouse is easy to install and offers you a host of useful features. The
Radio receiver can be conveniently placed to give you the freedom you need while working. The vertical wheel
allows you to scroll, or zoom in and out in a document. You can program the mouse buttons to launch the NetJump
or LuckyJump for a quick start to programs you run frequently. And, your RF-Mouse has a unique ID code, so other
RF (Radio Frequency) pointing devices won’t affect your system.

Connecting the RF-Mouse Receiver

The RF-Mouse receiver connects to your computer in the same way as a conventional
mouse allowing you to place the receiver wherever is convenient on your desktop.

1. Locate the round 6-pin PS/2 mouse port on the back of your computer.

2. Insert the PS/2 connector into the PS/2 port.

Locating the RF-Mouse Receiver

Your RF-Mouse has limitations on the range or distance from the receiver. To make sure that your mouse sends
and receives properly, refer to the following:

1. For optimal performance, place the receiver at least 8 inches (20 centimeters) away from other

electrical devices, such as the computer, the monitor, or external storage drives.

2. The RF-Mouse should be no farther than 3.3 feet (1.0 meter) from the mouse receiver. This will

ensure optimal communication between the mouse and receiver.

3. If you are working on a metallic surface, try using a mouse pad and turning the receiver face down for

better reception.

4. Switch frequency channels to prevent interference from other RF pointing devices. (See the following

section for more information.)

Selecting the Frequency Channel

The RF-Mouse operates on two frequency channels. To
prevent interference when using two RF Mice in close
proximity a different frequency channel should be used
for each mouse. Refer to the following to change the
frequency channel for your mouse:

1. Set the frequency channel on the receiver to 1 or

2.

2. Remove the battery cover from the mouse (see the

following Inserting the Batteries section).

3. Set the frequency channel on the mouse to 1 or 2.

(The frequency channel for mouse and receiver
must be the same.)

ONN

— 2 —