3M MP8630, 8640 Service Manual

3MP8630/8640 Multimedia Projector Quick Setup Instructions

Cable Connections: Always turn power off when making any cable connections.

Laser Disc

OUT

OUT

REDWHT

OUT

VCR

REDWHTYEL

Audio Right

Audio Left

S-VHS

MP8640

INININ

REDWHTYEL

RGB IN

RGB IN

RGB OUT

CONTROL

MAC

or PC

OUT

MONITOR

MONITOR

PORT

PS/2 or

SERIAL

PORT

MAC

Laptop

PORT

PC

IN IN IN

OUTOUTOUT

Audio L/R

Video

Technical Assistance & Product Information

1-800-328-1371

Internet: [e-mail]

Power

CRT

Display

VIS-78A

 3M 1997 78-6970-7971-9

3MP8630/8640 Multimedia Projector Quick Setup Instructions

Projector Packout

Packout Items not shown:

- PS/2 mouse cable

- ADB mouse cable

- Serial mouse cable

- Stereo mini-jack

Remote Control Transmitter

MAC Adapter
(with dip switch)

Projector Controls

Projector Start Up Procedure

1. With all power off, connect cables from projector to input devices.

2. Press the projector power switch (1) to the "ON" postion.

3. Slide lens shutter (2) to the open position.

4. Press the STANDBY/On button (3).

5. Raise or lower front projector feet to adjust image height.

6. Press the ZOOM button (4) to adjust the image size to fit the screen.
If needed, move projector closer or further from projection screen.

7. Press the FOCUS button (5) to adjust the image focus.

8. Turn on all connected equipment.

9. Press the INPUT button (6) on projector or INPUT SELECT­Video or RGB (6) on remote to select signal source.

Projector Shutdown Procedure

1. Press and hold STANDBY/ON button (3) for 3-5 seconds.

(The lamp turns off, the fan motor continues to run)

Caution

!

Do not turn off the projector power before pressing the STANDBY/ON

button. The fan motor will run for about 1 minute and cool the projector.

2. After fan stops, press main power switch (1) to "OFF".

3. Close the lens shutter (2) to protect lens.

4. Disconnect cables.