3R SYSTEM CASE K User Manual

Size:
795.36 Kb
Download

Series User Manual

Package Contents and Installation of the parts

Mainboard supporter - Use this only where required, and assemble using Paper Washer(Red Washer).

Paper Washer ‒ Use this with 3.5screws and mainboard supporter for electrical insulation.

Screw 3.5- Use this to secure Mainboard and PSU.

* How to assemble the Screw: Be sure to install the paper washer between

the Mainboard and the Screw(3.5 ) to prevent a short circuit.

How to connect cables

POWER LED+-

H.D.D LED +-

POWER LED : Refer to the manual and install it while obeying the polarities, If a 4-pinconnector is supported, then connect it to the power supply.

HDD LED : Refer to the manual and install it while obeying the polarities.

* In case of LED connector, the terminal with the ▲ mark is ‘+’.

POWER SW(Switch) : This switch has no polarity. POWER SWIt doesn’t matter which place you

connect this to the mainboard.

RESET SW

RESET SW(Switch) : This switch has no polarity.

 

It doesn’t matter which place you

 

 

 

 

connect this to the mainboard.

USB

AUDIO

: Connect it to the terminals on the Mainboard.

 

 

USB

AUDIO

 

Screw 3- Use this to secureCD-ROM,FDD and various PCI slot cards.

Screw(HDD) - Use this to secure HDD.

PC Speaker - This is installed in mainboard and calls the condition of the system.

Specifications and improvements in the design of our PC case are subject to change without any prior notice.

*Warranty voids when damage is caused by user’s abuse, misuse or

by a natural disaster.

*Warranty voids when damage is caused by modifying the product or by using the product in improper application.

For the detailed A/S and support, please visit our website. (http://www.3rsys.com)

TEL : 82 2 2027 2555 Fax : 82 2 2027 2088

e-mail :support@3rsys.com

How to connect cables

LCD RESET LCD SELECT

POWER RESET

Functions

*1-channeltemperature monitor

*1-channelfan speed control

*Auto fan speed control

40 : Low

50 : Mid

60 : High

*Immediate visual indication of Fan/HDD operation

*On-boardPower & Reset Switch

Buttons

*LCD RESET : Resets to default settings

*LCD SELECT : Switches fan speed from Low to Mid to High

*POWER SW : System Power Switch

*RESET SW : System Reset Switch

MODE

UP

RESET

DOWN

Functions

*1-channeltemperature monitor

*2-channelfan speed control

*6-levelfan speed control (manual)

*Fan speed storage function

*Auto fan speed control

40 : Low

50 : Mid

60 : High

*Immediate visual indication of Fan/HDD operation

*Displays system running time

Buttons

*LCD RESET : Resets to default settings

*MODE : Switches fan control channels

*UP : Increases fan speed (level 1 → level 6 → Auto)

*DOWN : Decreases fan speed (level 6 → level 1 → Auto)

How to connect cables

4-pinPower Supply Connector : Connect this to PSU. (Only available for the LCD product)

Fan Power Connector : Connect this to the 3-pinFan provided in the case.

(Only available for the LCD product)

Thermal Probe : Place this sensor to the proper place to measure the temperature inside the case.

* Do not place the sensor on CPU core, or Heatsink.

*If there is the gap between cooler base and CPU core because of the wire of the sensor, CPU may be damaged.

*If there is cooler guide, the cable of the sensor should be replaced under the cooler guide to avoid the disconnection.