ZyXEL Communications SP-200E User Manual

SP-200E

Statement Printer

User’s Guide

Version 1.00

7/2006

Edition 1

SP-200E User’s Start Guide

1 Introducing the SP-200E

The SP-200E is a 2-inch thermal printer with an integrated, easy-to-use, push-button control panel. It lets you generate subscriber accounts and print account information with the push of a button. It is also compact and portable and does not need a computer or printer. It is ideal for offices, coffee shops, libraries, hotels and airport terminals that provide Internet access for customers.

You can connect multiple SP-200Es to a single hotspot or service gateway to generate accounts in different locations.

2 Hardware Descriptions and Connections

2.1 Front Panel

1 Cover

2 Paper roll housing

3 Printing head

4 Buttons A~C

5 Cover release button

6 Tear bar

2.2 Rear Panel

1 Reset button

2 Power switch

3 DC power socket

4 Ethernet port (RJ-45)

5 PS/2 keypad port

Table 1 Rear Panel Hardware

SP-200E User’s Start Guide

1 2 3 4 5

Label Description

RST Press this button for 10 seconds to restore the factory default settings. The default IP

address is 192.168.1.1.

ON OFF Use this power switch to turn the printer on or off.

DC Use the printer’s included power adaptor to connect this power socket to a power supply.

POE RJ-45 port Use an Ethernet cable to connect this port to the gateway. You can use a mid-span POE

(Power Over Ethernet) injector (not included) instead of the power adaptor.

Yellow LED: 100 Mbps Link/ACT. This LED comes on when there is a 100 Mbps connection and blinks when sending or receiving traffic.

Green LED: 10 Mbps Link/ACT, green. This LED comes on when there is a 10 Mbps connection and blinks when sending or receiving traffic.

PS/2 keypad port Connect an optional PS/2 keypad to this port. Refer to the hotspot gateway User’s Guide for

information on how to configure the gateway for use with the SP-200E and the optional PS/ 2 keypad.

SP-200E User’s Start Guide

2.3 Front Panel Push-Buttons

Push the power switch to ON. The buttons on the front panel light up when the statement printer is receiving power. The following table describes push-button’s LED status and functions.

Note: If the printer prints continuously for two minutes, you must stop printing for at least eight minutes.

Table 2 Front Panel Push-Buttons

LED Status Printer mode Function

All Button LEDs Off

All Button LEDs On (Green)

Button A Blinking (Green)

Off All of the printer’s functions are stopped.

Hold button A down while you turn on the power to have the printer print a selftest.

On (Ready) Push a button to create a customer account with the configured account service

period. Refer to the gateway User’s Guide for information on how to configure the gateway for use with the SP-200E.

Out of paper/ Cover open

No function.

3 Loading Paper Rolls

Use the following steps to prepare the statement printer for use with a gateway.

1 Push the cover release button. 2 Open the cover.

+ 7 hidden pages