ZyXEL Communications P664HNT1 User Manual

P

-664HN-T1

802.11n

Quick Start

Dual

ADSL2+

Version 3.40

8/2010

Edition 1

4-port

Gateway

Guide

P-664HN-T1 Quick Start Guide

Overview

LAN IP address

http://192.168.1.1

default administrator password

1234

The P-664HN-T1 is a 802.11n Dual ADSL2+ 4-port Gateway with a four-port built-in
switch.

This Quick Start Guide shows you how to use the P-664HN-T1 to connect to the Internet and
how to configure the device settings to connect wirelessly.

See your User’s Guide for background information on all features.

Quick Login Information

2

P-664HN-T1 Quick Start Guide

1

Hardware

1 DSL: Use the gray telephone wire to connect your P-664HN-T1’s DSL port to telephone jack (or to

the modem port on a splitter if you are using one).

2 ETHERNET: Use the yellow Ethernet cable to connect a computer to an ETHERNET port for

initial configuration and/or Internet access.

3 POWER: Use the included power adaptor to connect an appropriate power source to the POWER socket.

Make sure the power source is on.

4 Push in the POWER button.
5 Look at the lights on the front panel.

• The POWER light blinks while your P-664HN-T1 starts up and stays on once it is ready.

• Each ETHERNET light stays on if the corresponding ETHERNET port is properly connected and blinks
when there is traffic.

• The DSL light is on when the P-664HN-T1 has a DSL connection.

• The INTERNET light is on when you are able to access the Internet and blinks when the P-664HN-T1
is sending or receiving data. Wait a couple of minutes while your device checks the connection.

If any of these lights are not on, check your connections and inspect your cables for damage. If the lights
are still off, contact your local vendor.

2

Internet Connection

Use this section to have your P-664HN-T1 automatically detect and set up your Internet connection.

1 Open your web browser to a website. Wait while your P-664HN-T1 tries to detect your DSL connection to
your

ISP. This may take a few minutes.

2 After it detects the connection, the DSL light shows green on your device and the Internet light comes on

when the Internet is ready for you to use. If you have a PPPoE connection, you will have to enter your

user name and password.

3 Go to section 3 if you wish to configure your wireless settings.
4 If you do not see the connection test screen, or the connection test is not successful, follow the

i nstructions i n the screen below, or check your connections and restart the P-664HN-T1. If you still
cannot access the Internet, follow the steps in section 3.

Connections

Setup: Automatic

3

Configuring your Wireless

To create a wireless network, the P-664HN-T1 and your wireless computer must all use the same
SSID (network name), channel and security settings.

If you do not set wireless security then anyone within range could use your P-664HN-T1 to access
your network and the Internet.

ChooseW PA-PSK wireless security if your wireless device supports it as it is stronger than W EP. Otherwise
chooseW EP.

Settings

3