Warnings call attention to a procedure or practice that
could result in personal injury if not correctly performed.
Do not proceed until you fully understand and meet the
required conditions.
Cautions call attention to an operation procedure or
practice that could damage the product if not correctly
performed. Do not proceed until understanding and meeting
these required conditions.
Notes provide information that can be helpful in
understanding the operation of the product.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference which may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
RF Notice
Any changes or modifications to equipment not expressly approved by Zebra
Technologies Corporation could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du
Canada.
This device and its antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnant en
conjonction avec une autre antenne ou transmetteur.
This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and your body
Cet équipement doit être installé et utilisé à une distance minimale de 20cm entre
le radiateur et votre corps.
It is the responsibility of the installer to ensure that when using the outdoor antenna
kits, only those antennas certified with the product are used. The use of any
antenna other than those certified with the product is expressly forbidden by FCC
rules 47 CFR part 15.204 and IC RSS standards.
Il est de la responsabilité de l'installateur de s'assurer que lorsque vous utilisez les
kits d'antennes extérieures, seules les antennes certifiés avec le produit sont
utilisés. L'utilisation d'une antenne autre que ceux qui sont certifiés avec le produit
est expressément interdite par la réglementation FCC partie 47 CFR 15.204 et IC
normes RSS.
• No modifications to the tag allowed. This includes any type of modification to the
case, such as adding metal foils, holes, disassembly or modificat ion s to the PCB
assembly, antenna, battery or modifications to the product labels, etc.
• Prior to installation, carefully inspect the tag, looking for crack, puncture or any
other breach of the plastic case. Damaged tags must not be used. Properly
dispose of any damaged tag.
• Never dispose of the tag in a fire.
• Deactivate the tag when not in use. It is mandatory to deactivate the tag prior to
shipment by airplanes.
• Follow limitations of use as set forth by any applicable regulatory bodies.
WARNING
• The tag contains replaceable primary Lithium Thionyl Chloride (Li-SOCl
)
2
batteries, which must be replaced only by trained service technicians. ZTC offers
service to replace the batteries. Please contact your ZTC account manager for
more information.
• Do not attempt to open the tag and modify the battery due to fire, explosion and
severe burn hazard. Do not recharge, short circuit, crush, dissemble, heat above
o
C (212 oF), incinerate, or expose contents of the battery to water.
100
• Do not dispose the tag or its lithium batteries in unsorted municipal waste. In
most countries, recycling programs are available through non-profit or ganization,
mandated by local government or organized on a voluntary basis. Contact your
local government for disposal practices in your area. ZTC offers recycling
programs in certain geographic areas. To determine if a program is available for
this product in your area, please refer to our web site at:
http://www.zebra.com/environment
.
• When not in use, the tag should be stored in dry and cool conditions at a
temperature preferably not exceeding +30