Zebra Technologies 7528HFA Users manual

WA99

05

/WA99

06 -

RFID MODULE

S HF-KR3

-2S/LF-ID1

INSTALLATION SHEET

Important: All Approval and safety information is outlined in the ‘WORKABOUTPRO4 Regulatory & Warranty Guide – part number 8000296 provided with each WORKABOUTPRO4.

Warning the rest of the body. This product must not be used in a holster or on a belt-clip.

:

The WORKABOUTPRO4 with the RFID option must not be held closer than 20 cm from

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..

February 12, 2014

80073681.A

1. Product Description

B

Easily installable expansion modules for the WORKABOUT PRO 4 allow you to customise this hand-held to meet your specific mobile computing requirements. This chapter outlines how to install the RFID Module HF/LF.

The RFID MODULE HF-KR3-2S (WA9905) or RFID MODULE LF-ID1 (WA9906) kits are composed of 7 parts:

A. PCB ASSY MODULE HF-KR3-2S or PCB ASSY MODULE LF-ID1 B. PLASTIC MULTIPURPOSE ENDCAP C. RUBBER PCB GUIDE D. STOPPER BRACKET E. USB CABLE F. LABEL CE/FCC/IC FOR WORKABOUTPRO4 G. INSTRUCTION SHEET WAP4 HF/LF RFID MODULE

A

D

E

C

G

F

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..

February 12, 2014

80073681.A

2. Product Installation

Before installing a module in the WORKABOUT PRO 4, all power sources must be turned off.

• Remove the batteries. If your unit is using AC power, disconnect it.

With the power shut down, you can install the RFID Module HF/LF.

• Connect the USB cable on the RFID Module.

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..

• Slide the RFID Module in the PCB guide.

February 12, 2014

80073681.A

•

Make sure you slide HF PCB only in the bottom slot of the PCB guide LF PCB

Adding SAM cards (optional):

• Insert one or two SAM cards in their sockets:

Unlock 1 or 2 SAM sockets Put 1 or 2 SAM cards and lock them

• Slide the PCB guide in the Multi purpose End Cap.

• Slide and Screw the stopper into the Multi purpose EndCap.

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..

February 12, 2014

80073681.A