Zebra WA6080 Quick Start Guide

Velcro Disk s

WA6080 Closed

WA6081 Open-ended

CARRYING CASES - WA6180 SHORT CLOSED, WA6080 LONG CLOSED, WA6181 SHORT OPEN-ENDED, WA6081 LONG OPEN-ENDED INSTALLATION

Important: Open-ended carrying cases (WA6181 short or WA6081 long, depending on the unit) are designed for

Workabout Pro4s with scanner/imager/multipurpose end-caps installed.

Closed carrying cases (WA6180 short or WA6080 long) are designed to fit units with blank/standard endcaps installed

1. Pull open the flap at the bottom of the carrying case, and unzip the zippers along the sides of the case.

Important: Open-ended carrying cases have Velcro disks included with them to help secure the Workabout Pro4 to the

carrying case.

Remove the velcro disks attached inside on either side of the case. Strip the plastic from the disks and apply a disk to each side of the Workabout Pro4, above the side buttons.

2. Slide the unit into the carrying case.

3. Check that the unit is aligned properly in the case with the display and keyboard clearly visible.

4. Fasten the zippers on either side of the unit, and press the velcro bottom flap in place.

Important: For open-ended cases, press on either side of the case where the velcro disks are located to secure the

Workabout Pro4 to the case.

Zebra and the Zebra head graphic are registered trademarks of ZIH Corp. The Symbol logo is a registered trademark of Symbol Technologies, Inc., a Zebra Technologies company.

February 27, 2015

8000354-001 A

Belt Clip

Attach on either side of case

All carrying cases are shipped with a belt clip.

1. Attach the clips onto the rings on either side of the case.

2. Use the belt clip to hook the carrying case onto your belt.

COMPANY HEADQUARTERS SUPPORT SERVICES Zebra Technologies Corporation Contact the Zebra Global Customer Support at: Lincolnshire, IL U.S.A. http://www.zebra.com/support. http://www.zebra.com