CONTENTS OF THE BOX
The VH10
This guide and any additional
documentation (dependent on order)
VH10 FEATURES
FRONT
Type B Micro-USB port (inside dome
Antenna
(optional)
Power button
Power LED
Warning LED
plate - for service personnel only)
Antenna
(optional)
Function keys and
Macro keys
BACK
VEHICLE DC SUPPLY CONNECTIONS
Without power pre-regulator
Extension power cable
Diode/choke assembly
DO NOT USE
Cable kit 13985-301 includes an extension power cable with additional
lines to connect to the Ignition Switch.
Cable kit 13985-302 includes an extension power cable without lines
for the Ignition Switch.
Mounting hardware is packed separately, according to your order.
Extension wire
Fuse assembly
OPTIONAL PARTS
Adaptor cable with lines for
Magmount and remote
external antenna
ignition switch
AC power adaptor
DB9 screen blanking cable
Function keys
Macro keys
BOTTOM
Cable bay cover
Display
Orange Modifier key
Blue Modifier key
ENTER/Power key
SYM key
Ground lug
Unused ports should be covered with dust caps.
Beeper
Power cable
Ven t
PORTS
Strain
relief
brackets
Audio jack
Powered USB host port
Cable bay cover removed
UART RS-232 ports
USB host port
VH10 power cable
Extension power
cable
Negative
connection
DB9 cable
Lines to screen-blanking
sensor (optional)
Lines to ignition switch
(optional)
Caution: Do not use the
diode/choke assembly in the
Extension Power Cable kit
Extension wire
Fuse
Positive
connection
Vehicle DC power source
(12VDC to 48VDC nominal)
OVER
>
VEHICLE DC SUPPLY CONNECTIONS
With power pre-regulator
VH10 power cable
DB9 cable
Lines to screen-blanking
sensor (optional)
Lines to ignition switch (optional)
Power pre-regulator
(Model PS1370)
GETTING STARTED
1
Attach the mount to the VH10 and to the vehicle. Refer to the
mounting instructions in the VH10 Vehicle-Mount Computer User
Manual, PN 8000275.
Position the VH10 in the vehicle.
2
Connect the VH10 to the external magmount antenna, if
3
necessary.
Antenna connector
Connect the VH10 to the vehicle DC supply.
5
6
To power the unit on or off, press the Power button located at
the top of the unit.
Calibrate the touchscreen, if necessary.
7
Configure the radio, software, and peripherals. Refer to the VH10
8
Vehicle-Mount Computer User Manual, PN 8000275.
VH10
VEHICLE-MOUNT
COMPUTER
QUICK START
GUIDE
Caution: Do not use the
diode/choke assembly in the
Extension Power Cable kit
Negative
connection
Extension power cable
(without ignition switch)
Extension wire
Fuse
Positive
connection
Vehicle DC power source
(48VDC to 72VDC nominal)
Connect peripherals to the
4
VH10, placing their cables
into the strain relief brackets
inside the cable bay. Then
replace the cover.
Bottom of VH10 with cable bay
cover removed.
Mount the antenna
so that it is vertical
Cable bay
Strain
relief
brackets
Cable bay
cover
© Copyright 2013 by Psion Inc.
2100 Meadowvale Boulevard, Mississauga, Ontario, Canada L5N 7J9
http://www.psion.com
Psion, the Psion logo, and the names of other products and services provided by
Psion are trademarks of Psion Inc. All trademarks used herein are the property of
their respective owners.
8 0 0 0 2 8 2
February 12, 2013
PN 8000282.A
ISO 9001 Certified
Quality Management System
Loading...