Zebra P1011898 User Manual

Zebra Technologies Corporation

475 Half Day Road, Suite 500
Lincolnshire, IL 60069 USA

Zebra

®

RW 420 Mobile Battery

Eliminator Kits

Installation Instructions

P1010425 Rev. H
September, 2010

RW 420 Mobile Battery Eliminator Kits

Special Notices

The following notices emphasize certain information in the guide. Each serves a special purpose

and is displayed in the format shown:

Note: Note is used to emphasize any signicant information.

Caution: Indicates information that, if not followed, can result in damage to software, hardware, or

data.

Warning: This warning symbol indicates an imminently hazardous situation which, if not avoided will

result in death or serious injury. Before you work on any equipment, be aware of the hazards involved
with electrical circuitry and be familiar with standard practices for preventing accidents

General Warnings and Cautions

Caution: Read the following installation instructions before you connect the system to its power source.

Note: Zebra Technologies Corporation is not liable for personal injury or damage to any equipment

caused by the improper installation of this equipment to any power source.

Vehicle Installation Safety

Caution: Only trained and qualied personnel should be allowed to install, replace, or service
this equipment.

Caution: DO NOT USE THE PRINTER WHILE DRIVING, as this may result in property damage
or personal injury. Zebra Technologies Corporation. does not promote the use of these products
except when parked or stationary, and is not responsible for any loss resulting from the use or
misuse of our products.

Caution: Do not install the battery eliminator kit where it will be exposed to precipitation,
extreme temperatures or excessive condensation.

Caution: Do not install the battery eliminator kit in a location that will aect vehicle safety or
drivability.

pg. 2 P1010425 Rev. H

Caution: Never install or remove the equipment from the vehicle’s electrical system while the ve­hicle is running. This may result in permanent damage to the equipment.

Warning: It is very important to ensure that you make the correct cable to power source connec­tions, because electrical energy from a vehicle’s power system can harm equipment and people.

Ensure that the Power Supply has proper cooling. Do not place any padding or cushioning material

under the unit or next to the back of the unit.

Electrical Information

Power Supply Input: 11VDC to 16VDC

Caution: Since the RW 420 Mobile Battery Eliminator consumes vehicle power even when the

printer is turned o, it MUST be connected to a power source that is switched o when the vehicle is
turned o.

Zebra Technologies Corporation is not liable for damage to any equipment caused by improper installa­tion of this equipment to any power source.

Regulatory Information

Regulatory Markings

Type-approval labels indicate compliance with country regulations. This product carries country-

specic labels to indicate compliance.

Radio Frequency Interference Regulations

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) this device must accept any
interference received including interference that may cause undesired operation.

P1010425 Rev. H pg. 3