Zebra Omnii XT15 Omnii Pistol Grip Installation Sheet English

Trigger Cover

OMNII™ PISTOL GRIP INSTALLATION
& REMOVAL INSTRUCTIONS

1. Introduction

There are a number of pistol grips available depending on the type of back cover and scanner/imager installed in
your hand-held. Refer to the table below for a list of pistol grip model numbers along with the types of back covers
and scanners/imagers with which they are compatible.

ACCESSORY MODEL NUMBER

Pistol Grip ST6000 – Kit Pistol Grip Standard Pod

Pistol Grip Trigger Cover ST6104

2. Removing the Trigger Cover

Warning: If you are removing an existing pistol grip, skip this step and follow the steps described under

“Removing the Pistol Grip” on page 2.

Before installing the pistol grip, you need to remove the trigger cover.

• Using a flathead screwdriver, carefully pry the trigger cover off the hand-held.
Figure 1 Removing the Trigger Cover

ST6100 – Kit Pistol Grip Standard Back A
ST6300 – Kit Pistol Grip Flush Mount
ST6400 – Kit Pistol Grip Standard Back B

3. Attaching the Pistol Grip

Important: If you are replacing an existing pistol grip, you’ll need to follow the steps described under “Removing

Prior to installation, make sure the trigger mechanism is securely snapped into the pistol grip body and that the
trigger operates properly.

The pistol grip is attached to the back cover of your Omnii using the four threaded inserts in the upper part of the
Omnii casing. Four M3x6 Phillips head screws are provided with this accessory.

• Position the pistol grip so that it fits snugly over the back of the unit and the holes in the pistol grip are
aligned with the threaded inserts on the back of the hand-held. Figure 2, Attaching the Pistol Grip, provides
a visual illustration.

• Using a Phillips screwdriver, tighten the screws to a torque of 3 in-lb (3.5 Kgf-cm) to secure the pistol grip
in place.

© Copyright 2012 by Psion Inc.

2100 Meadowvale Boulevard, Mississauga, Ontario, Canada L5N 7J9
http://www.psion.com Psion, the Psion logo, and the names of other products and services provided by Psion are trade-

marks of Psion Inc. All trademarks used herein are the property of their respective owners.

the Pistol Grip” on page 2 before following the steps in this section.

October 10, 2012

8000212.D
Sheet 1 of 1

Figure 2 Attaching the Pistol Grip

4. Removing the Pistol Grip

• Remove the 4 screws holding the pistol grip in place.

• Clean the perimeter of the trigger cover area with isopropyl alcohol.

Important: If you are replacing an existing pistol grip with a new pistol grip, remove the screws and clean the perimeter

• Fit the trigger cover over the opening, and press it firmly into place.

COMPANY HEADQUARTERS SUPPORT SERVICES
Psion Inc. For local support services, go to:

2100 Meadowvale Boulevard, Mississauga http://www.psion.com/service-and-support.htm
Ontario, Canada L5N 7J9
Tel: [phone]
Fax: [phone]

of the trigger cover as described above, and then skip the last step in this section. Follow the steps under
“Attaching the Pistol Grip” on page 1 for details about installing a new pistol grip.