Zebra 8585 Vehicle-Mounted Computer Installation Instruction for MT3512 RAM VESA PLATE Mounting Kit English
Installation Instruction for MT3512 RAM VESA PLATE
Mounting Kit
WARNING:
serious injury or damage to property. Contact Psion Technical Support or your Psion
representative if you have problems installing this mount. To ensure operator safety, you must
use a calibrated torque wrench and the supplied mounting hardware when fastening the cradle and
mount. Use of this mount in vehicles driven on public roads or highways is prohibited. Contact
Psion for further deta i ls.
Before mounting an 8585/8595 in a vehicle, there are a number of operator safety issues that
require careful attention. An improperly mounted 8585/8595 may result in one or more of the
following: operator injury, property damage, operator visibility obstruction, operator distraction
and/or poor ease of egress for the operator. Psion strongly recommends that you seek professional
mounting advice from the vehicle manufacturer.
When mounting an 8585/8595 use only approved Psion mounting hardware and mounting parts
which are specific to the 8585/8595 model purchased. Use of non-approved parts may result in
one or more of the following: operator injury, property damage, operator visibility obstruction,
operator distraction and/or poor ease of egress for the operator.
If it is necessary to mount the 8585/8595 overhead or in any position that could cause injury to
the operator should the unit fall, it is critical that a secondary tether or other failsafe device be
installed.
Failure to install the mount correctly or modifications to the mount may result in
The following restrictions must be strictly enforced:
• Do not use the mount and/or the 8585/8595 as a hand-hold. Using the mount in this
manner may cause the person to fall or dislodge the mounting hardware and/or mounts.
• Do not add weight or attach any other items to the mount or 8585/8595. Additional
elements may fall causing injury or may increase chance of failure and/or damage in
mounting hardware and/or mounts.
Mounts used in industrial or vibration generating environments may be subjected to fatigue, stress
and/or part wear. A periodic inspection of the mounting hardware and mounts should be
performed to ensure parts are retightened to the correct torque, free of fractures, excessive wear
and/or other environmental damage. Any parts found to be unsafe should be removed and
replaced immediately.
Part No. 1616805 Revision B
Sheet
1 of 2
Legend:
A
8585/8595 VMT(Not supplied)
B
RAM Vesa Base (Small)
C
Washer M6 Flat
D
Washer M6 Spring
E
Screw M6 x 16 Hex Socket
Figure 1
Step 1: Assemble RAM Base to 8585/8595
Section A
A1. Installation
VMT: For assembling the RAM Vesa Base (B)
to the 8585/8595 Terminal (A) see Figure 1.
Appendix A: Support Services
For technical support, please visit: http://zebra.com/support
: Apply Loctite 243 to Scre w (E) threads
(Note: Loctite not supplied by Psion). Place Screw
(E) through Spring Washer (D), Flat Washer (C),
RAM Vesa Base (B) and affix to 8585/8595 Terminal
(A). Four places. Torque to 18 lbf-in.
Part No. 1616805 Revision B
Sheet
2 of 2
Loading...