Important! Read carefully & keep for future reference.
• The safety of Your appliance complies with the industry
standards and with legal requirements on the safety of
appliances. However, as manufacturers, we feel it is
our duty to provide the following safety notes.
• It is most important that this instruction book should
be retained with the appliance for future reference.
Should the appliance be sold or transferred to another
owner, or should you move house and leave the appliance, always ensure that the book is supplied with the
appliance in order that the new owner can get to know
the functioning of the appliance and the relevant warnings.
• You MUST read them carefully before installing or using the appliance.
• Before first starting up, check the appliance for any
damage incurred during transport. Never connect up a
damaged appliance . If parts are damaged, contact your
supplier.
• If the appliance is delivered in the winter months when
there are minus temperatures. Store it at room temperature for 24 hours before using for the first time.
General safety
• It is dangerous to alter the specifications or attempt to
modify this product in any way.
• During high temperature wash programmes the door
glass may get hot. Do not touch it!
• Make sure that small pets and children do not climb
into the drum. To avoid this, please check into the
drum before using.
• Any objects such as coins, safety pins, nails, screws,
stones or any other hard, sharp material can cause ex-
tensive damage and must not be placed into the machine.
• Only use the advised quantities of fabric softener and
detergent. Damage to the fabric can ensue if you overfill. Refer to the manufacturer’s recommendations of
quantities.
• Wash small items such as socks, laces, washable belts
etc in a washing bag or pillow case as it is possible for
such items to slip down between the tub and the inner
drum.
• Do not use your washing machine to wash articles with
whalebones, material without hems or torn material.
• Always unplug the appliance and turn off the water
supply after use, cleaning and maintenance.
• Under no circumstances should you attempt to repair
the machine yourself. Repairs carried out by inexperienced people may cause injury or serious malfunctioning. Contact your local Service Centre. Always insist on genuine spare parts.
Installation
• This appliance is heavy. Care should be taken when
moving it.
• When unpacking the appliance, check that it is not
damaged. If in doubt, do not use it and contact the
Service Centre.
• All packing and transit bolts must be removed before
use. Serious damage can occur to the product and to
property if this is not adhered to. See relevant section
in the user manual.
• After having installed the appliance, check that it is not
standing on the inlet and drain hose and the worktop is
not pressing the electrical supply cable against the
wall.
2
• If the machine is situated on a carpeted floor, please
adjust the feet in order to allow air to circulate freely
under the appliance.
• Always be sure, that there is no water leakage from hoses and their connections after the installation.
• If the appliance is installed in a location subject to
frost, please read the “dangers of freezing” chapter.
• Any plumbing work required to install this appliance
should be carried out by a qualified plumber or competent person.
• Any electrical work required to install this appliance
should be carried out by a qualified electrician or competent person.
Use
• This appliance is designed for domestic use. It must
not be used for purposes other than those for which it
was designed.
• Only wash fabrics which are designed to be machine
washed. Follow the instructions on each garment label.
• Do not overload the appliance. See the Washing Programme Table.
• Before washing, ensure that all pockets are empty and
buttons and zips are fastened. Avoid washing frayed or
torn articles and treat stains such as paint, ink, rust,
and grass before washing. Underwired bras must NOT
be machine washed.
• Garments which have been in contact with volatile petroleum products should not be machine washed. If
volatile cleaning fluids are used, care should be taken
to ensure that the fluid is removed from the garment
before placing in the machine.
• Never pull the power supply cable to remove the plug
from the socket; always take hold of the plug itself.
• Never use the appliance if the power supply cable, the
control panel, the working surface or the base are dam-
aged so that the inside of the washing machine is accessible.
Child safety
• This appliance is not intended for use by person (including children) with reduced physical sensory or
mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do
not play with the appliance.
• The packaging components (e.g. plastic film, polystyrene) can be dangerous to children - danger of suffocation! Keep them out of children’s reach
• Keep all detergents in a safe place out of children’s
reach.
• Make sure that children or pets do not climb into the
drum. To prevent children and pets becoming trapped
inside the drum this machine incorporates a special
feature.
To activate this device, rotate the button (without
pressing it) inside the
door clockwise until the
groove is horizontal. If
necessary use a coin.
To disable this device and
restore the possibility of
closing the door, rotate the
button anti-clockwise until
the groove is vertical.
3
Product description
Detergent dispenser drawer
1
Control panel
2
Door opening handle
3
Rating plate
4
Drain pump
5
Adjustable feet
6
1
6
2
3
4
5
Detergent dispenser drawer
Compartment for detergent used for prewash and soak
phase or for stain remover used during the stain action
phase (if available). The prewash and soak detergent is
added at the beginning of the wash programme. The stain
remover is added during the stain action phase.
Compartment for powder or liquid detergent used for
main wash. If using liquid detergent pour it just before
starting the programme.
Compartment for liquid additives (fabric softener,
starch).
Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the
detergent dispenser drawer. Any fabric softener or starching additives must be poured into the compartment before
starting the wash programme.
Flap for powder or liquid detergent (see "Flap
for powder or liquid detergent" in the chapter "Daily
use" for more details).
4
MAX
Control panel
Below is a picture of the control panel. It shows the programme selector dial as well as the buttons and pilot lights.
These are presented by relevant numbers on the following pages.
1234576
Programme selector dial
1
SPIN reduction button
2
OPTIONS button
3
EXTRA RINSE button
4
START/PAUSE button
5
DELAY START button
6
Indicator pilot lights
7
Programme selector dial, spin speed button and available options
Programme Selector Dial
It allows you to switch the appliance on/off and/or to select a programme.
Available options:
Spin
By pressing this button you can change the spin speed of
the selected programme or to select Rinse Hold option.
Rinse hold
By selecting this function the water of the last rinse is not
emptied out to prevent the fabrics from creasing. Before
opening the door it will be necessary to empty out the water. To empty out the water, please read the paragraph «At
the end of the programme».
Prewash
By selecting this option the machine performs a prewash
cycle before the main wash phase. The washing time will
be prolonged. This option is recommended for heavily
soiled laundry.
Super Quick
Short cycle for lightly soiled items or for laundry which
needs only freshening up. We recommend you to reduce
the fabrics loading.
Extra Rinse
This appliance is designed to save energy. If it necessary
to rinse the laundry using an extra quantity of water (extra
rinse), select this option. Some additional rinses will be
performed. This option is recommended for people who
are allergic to detergents, and in areas where the water is
very soft.
Start Pause
This button allows you to start or to interrupt the selected
programme.
Delay Start
The start of the programme can be delayed by 3, 6 or 9
hours by means of this button.
5
Indicator pilot light (7)
First use
When selecting a washing programme both lights 7.1
and 7.2 illuminate.
After having pressed the button 5 the only light corresponding to the running phase stays on. The machine
starts working and the door is locked.
The light 7.3 illuminates at the end of the washing cycle. After a few minutes the door can be opened.
If the draining programme is selected any light
will illuminate.
• Ensure that the electrical and water connections
comply with the installation instructions.
• Remove the polystyrene block and any material
from the drum.
• Pour 2 litres of water into the main wash compartment
of the detergent drawer in order to
Daily use
Load the laundry
Open the door by carefully
pulling the door handle
outwards. Place the laundry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
Make sure that no laundry
stays between the seal and
the door. There is a risk of
water leakage or damage
to the laundry.
activate the ECO valve. Then run a cotton cycle at
the highest temperature without any laundry in
the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure
of detergent into the main wash compartment and
start the machine.
Measure out the detergent and the fabric softener
XAM
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
or in the appropriate compartment if the selected programme/option it requires
(see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
X
A
M
6
Flap for powder or liquid detergent
UP- The flap position if
using POWDER detergent
DOWN - The flap position
if using LIQUID detergent
during main wash
If the flap is not in the desired position:
• Pull out the dispenser
drawer until it stops.
MAX
The flap is down and you wish to use powder detergent:
• Turn the flap up.
• Measure out the detergent.
MAX
• Pour the powder detergent into the main wash
compartment
.
• Remove the remaining powder form the flap.
• There is remaining powder detergent in the
main wash compartment at the end of a washing programme. Check if the flap is in the right
position.
The flap is up and you wish to use liquid detergent:
• Turn the flap down.
• Measure out the detergent.
MAX
For the quantity of
detergent, refer always to what is written on
the product packing and
ensure that the detergent
can be poured in the drawer.
•
Pour the liquid detergent in the compartment
without exceeding the limit indicated in the flap.
• Close the dispenser drawer.
Warning! Do not use the flap in "DOWN" position
with:
• Gelatinous detergent or thick detergent.
• Powder detergent.
• With programmes with prewash.
• Do not use liquid detergent if the washing programme
doesn't start immediately.
In these cases, use the flap in "UP" position .
Select the required programme by turning the
programme selector dial (1)
Turn the programme selector dial to the required programme. The washing machine will automatically select
the maximum spin value provided for the programme you
have chosen. You can change this value by pressing the
corresponding button. The green pilot light of the button 5
starts to flash.
7
The selector dial can be turned either clockwise or counterclockwise. Turn to position
Switching the machine off.
At the end of the programme the selector dial must be
turned to position
Caution! If you turn the programme selector dial to
another programme when the machine is working,
the red pilot light of button 5 will blink 3 times to indicate
a wrong selection. The machine will not perform the new
selected programme.
, to switch the machine off.
to reset programme/
Select the spin speed or Rinse Hold by pressing
button 2
When selecting a programme, the appliance proposes automatically the maximum spin speed provided for that
programme. (See "Washing programmes" for the maximum allowed spin speed).
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a different speed. The
relevant pilot light illuminates.
Select the available options by pressing buttons 3
and 4
Depending on the programme, different functions can be
combined. These must be selected after choosing the desired programme and before starting the programme.
When these buttons are pressed, the corresponding pilot
lights illuminate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected, the integrated red pilot light of the button 5 flashes for 3 times.
For the compatibility among the washing pro-
grammes and the options see chapter «Washing
Programmes».
Select the Delay Start by pressing button 6
Before you start the programme, if you wish to delay the
start, press the button 6 repeatedly, to select the desired
delay. The relevant light illuminates.
You must select this option after you have set the programme and before you start the programme.
You can cancel or modify the delay time at any moment,
before you press button 5.
Selecting the delayed start:
1.Select the programme and the required options.
2.Select the delay start by pressing the button 6.
3.Press button 5:
– the machine starts its hourly countdown.
– The programme will start after the selected delay
has expired.
Cancelling the delayed start after having started the programme:
1.Set the washing machine to PAUSE by pressing but-
ton 5.
2.Press button 6 once, the light relevant to the selected
delay goes off
3.Press button 5 again to start the programme.
The Delay Start can not be selected with DRAIN programme.
Important! The selected delay can be changed only after
selecting the washing programme again.
The door will be locked throughout the delay time. If you
need to open the door, you must set the machine to
PAUSE (by pressing the button 5) and then wait a few
minutes. After you have closed the door, press the button
5 again.
Start the programme by pressing button 5
To start the selected programme, press the button 5, the
corresponding green pilot light stops blinking. The pilot
light corresponding to the running phase illuminates. The
appliance starts operating and the door is locked.
To interrupt a programme which is running, press the button 5: the corresponding green pilot light starts blinking.
To restart the programme from the point at which it was
interrupted, press the button 5 again. If you have chosen a
delayed start, the machine will begin the countdown.
If an incorrect option is selected, the red pilot light of the
button 5 blinks 3 times.
Interrupting a programme
Press the button 5 to interrupt a programme which is running, the corresponding green pilot light starts blinking.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a programme which
is running. Now you can select a new programme.
Opening the door
After the programme has started the door is locked. If, for
any reason, you need to open it, set firstly the machine to
PAUSE by pressing the button 5. After a few minutes it
will be possible to open the door.
If the door remains locked, this means that the machine is
already heating or that the water level is too high. In any
case, do not try to force the door!
8
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.