Zanussi ZSF 2420 User Manual

822 61 11-16
DISHWASHER
ZSF 2420
- 2 -
Contents
For the user
Safety Information 3 Description of the appliance 4-5
- Spray arm
- Coarse strainer/microfilter
- Fine filter
- Detergent dispenser
- Rinse aid dispenser
- Water softener
The control panel 6
- How to set the delayed start
- Starting the programme
- Interrupting the programme temporarily
- Cancelling the programme
- Cancelling the drying phase
- Switching the dishwasher off
- Service and Spare Parts
- Customer Care Department
Guarantee Conditions 14
For the Installer
Technical Specifications 15 Unpacking 16
- Damages
- Use
- Positioning
Installation 17-18
- Water inlet
- Water drainage
- Power supply
Information for test centres 19
Guide to use the instruction book
The following symbols will be found in the text to guide you throughout the instructions:
Safety information Step by step instructions Hints and tips Environmental information
Before installing and first using the dishwasher, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dishwasher are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety.
Installation and servicing
All installation and service work done on the product
must be carried out by a qualified technician. Work performed by persons with inadequate knowledge may adversely affect the satisfactory functioning of the product and may cause personal injury or damage. Before any work is carried out on the dishwasher, it must be isolated from the electrical supply. To do this the power plug must be removed from the wall socket.
Water connection should be made via an easily
accessible tap.
The power cable must be plugged into an earthed
socket, which must to be easily accessible. Permanent installation must only be carried out by an authorised electrician or competent person.
If the power cable is damaged, it must be replaced
by a Service Force engineer. Please contact your local service centre on 08705 929 929.
Make sure that the power cable is not nipped or other-
wise damaged and that the hoses do not get crushed or kinked when moving the dishwasher when installing or cleaning etc.
Servicing and possible repairs must be carried out by
a Service Force engineer. Always insist on genuine spare parts. Never try to repair the dishwasher yourself.
Child Safety
The dishwasher should be used by adults only. Do not
let children play with the controls or other parts of it.
Do not allow children to play with the packaking. Risk
of suffocation.
Keep all detergents in safe place out of children´s
reach.
Prevent children from sitting, swinging or standing
on the open door.
During Use
This dishwasher is designed solely for washing house-
hold utensils suitable for machine washing. Using it for other purposes could lead to physical injury or damage to property and invalidate the guarantee.
Avoid opening the door while the dishwasher is running,
as hot steam may escape.
Only use detergent specifically designed for use in
dishwashers.
Do not place sharp knives with their points upwards.
It is much safer to lay them horizontally in the basket.
Ensure that the door of the dishwasher is always closed
when it is not being loaded or unloaded. In this way you will avoid anybody injuring themselves on the open door.
If you take any dishes out of the dishwasher before the
end of the dishwashing cycle, it is extremely important to rinse them thoroughly under running water to remove any remaining detergent.
The water safety system protects against water damages.
The following requirements must be fulfilled:
- The dishwasher must be electrically connected when it is switched off.
- The dishwasher must be correctly installed.
- Always shut off the water supply whenever the dish­washer is left unattended for an extended period.
In the event of flooding or leakage, switch off the water
supply immediately by closing the stopcock and dis­connect the power supply by unplugging the power cable or removing the fuse. When removing the electrical plug, grip the plug, not the cable. Never touch the
switch or plug with wet hands!
Conservation
- packaging:
All materials used in packaging this appliance are environmentally-friendly. The various plastics used are identified and can be recycled:
PE stands for polyethylene, which is used for the
bag around the appliance and the bag in which these instructions were supplied.
PS stands for polystyrene (moulded), which is used
for the sections of packaging needed to cushion the appliance.
The cardboard components of the packaging are made from recyclable paper and should be taken to a collection point for recycling.
- old apparatus:
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
Safety information
- 3 -
822 61 11-16
Description of the appliance
- 4 -
4 5
- 5 -
Spray arm (1)
It is important to keep all the holes in the spray arm clear. A clogged hole can seriously affect washing efficiency. If the spray arm needs cleaning, unscrew the nut anti­clockwise, remove the washer and lift off the spray arm. Clear the holes and shake out any food remnants.
Coarse strainer/microfilter (2)
The purpose of the coarse strainer is to catch large objects such as a cocktail stick and pieces of eggshell. Make sure that the strainer is always clean. Turn the coarse strainer anti-clockwise. Lift it out and rinse it under running water whenever necessary.
Fine filter (3)
It is just as important to keep this filter clean. A dirty or clogged filter will always impair washing efficiency. The fine filter can easily be lifted out for cleaning when you have removed the coarse strainer.
Detergent dispenser (4)
Open the lid to the dispenser by pressing the lid catch towards the compartment. Consult the instructions on the detergent packet, fill the compartment accordingly and close the lid. Remember that the instructions usually refer to full-size dishwashers, for example when using detergent tablets, it is sufficient to use just half a tablet. Pre-wash detergent is poured into the smaller compartment to the left when needed. This detergent is used during the pre­rinsing. Make sure that nothing prevents the lid from opening.
Only use detergents specially designed for dishwashers.
Rinse aid dispenser (5)
Use of rinse aid will result in cleaner and faster drying of the load, since it helps water and residues to run off. Too much rinse aid may result in streakiness, too little may cause white spots. The dispenser holds about 150 ml. This is enough for approx. 60 wash cycles, depending on the dosage setting. Adjust the dosage setting according to the hardness of the water.
You can set the dosage between 1 - 6, the appli­ance is factory set to 1. Begin at the lowest dosage setting and increase if necessary by turning the setting arrow with e.g. the handle of a spoon.
The amount of rinse aid can be checked trough the lens on the dispenser. When the lens is clear, requires refilling of rinse aid.
1. Open the lid to the dispenser by pressing the lid catch towards the compartment and lift the lid.
2. Fill up with rinse aid; do not overfill.
3. Wipe off any spillage carefully to prevent excessive foaming during the next wash programme.
4. Close the lid and press until it locks again.
Do not fill the rinse aid dispenser with liquid detergent.
Zanussi recommends the use of Finish dish­washer detergent and Rinse Aid.
Water softener (6)
This dishwasher is equipped with a water softener for hard water. The lime in hard water causes white deposits to occur on dishes and to the interior of the dishwasher. To prevent this, the water has to pass through a special container where the hardness is removed. Since the water softener uses dishwasher salt, you will have to refill the salt container after a certain number of dishwasher cycles.
It is extremely important, that the salt container is filled up with the dishwasher salt before using the dishwasher for the first time.
The indicator light on the control panel is lit when the container requires refilling.
1. Unscrew the filler cap to the salt container anti-
clockwise.
2. Fill the salt container with water (only the first time).
3. Fill the container with dishwasher salt, using the funnel supplied.
4. Remove the funnel and wipe off any spillage around the filler opening.
5. Screw the filler cap back properly in place.
The water softener is now ready for the first load of dishes. Always make sure that there is dishwasher salt in the container, which holds about 1 litre. How to adjust the water softener, see chapter ”Adjusting the water softener”.
Only use special salt for dishwashing machines, ordinary domestic salt, especially table salt, can damage the water softener.
Programme selector
Turn the programme selector clockwise or anticlockwise to select the programme and temperature according to the programme chart.
Start/Cancel button
In addition to starting a programme you can, by pressing this button, adjust the setting of the water softener and cancel a programme in progress.
= reset position
Indicator lamps:
Shows current phase of the selected programme.
• Wash cycle in progress top lamp
• Drying in progress middle lamp
• Programme cycle lowest lamp ended
Control lamp:
Shows that refilling of salt container is necessary
The programme start can be delayed by 3 hours.
1. Select the desired dishwashing programme. The programme indicator lamps starts to flash.
2. Press the delay start button. The lamp for the delayed start lights up.
3. Press the start button. The programme indicator lamps goes out. The programme will start when 3 hours have elapsed.
Cancelling the delayed start:
Press the delay start button, the lamp for the delayed start goes out. The required programme starts immediately.
The control panel
- 6 -
Start/Cancel
button
Programme selector
Delay start button
Reset position
On/Off Indicator
lamp
Indicator and control lamps
How to set the delayed start
Loading...
+ 14 hidden pages