Zanussi ZR220/2TN Instruction Manual

FRIGORIFEROCONGELATORE

FRIDGE-FREEZER KÜHL-

GEFRIERSCHRANK REFRIGERATEUR-

CONGELATEUR

ZR 220/2TN

LIBRETTO ISTRUZIONI INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG MODE D’EMPLOI

2222 255-05/2

WARNINGS

It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.

These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance.

General Safety

ª This appliance is designed to be operated by

adults. Children should not be allowed to tamper with the controls or play with the product.

ª It is dangerous to alter the speciﬁcations or modify

this product in any way.

ª Care must be taken to ensure that the appliance

does not stand on the electrical supply cable.

ª Before any cleaning or maintenance work is

carried out, be sure to switch off and unplug the appliance.

ª This appliance is heavy. Care should be taken

when moving it.

ª Ice lollies can cause frost burns if consumed

straight from the appliance.

Service / Repair

ª Any electrical work required to install this

appliance should be carried out by a qualiﬁed electrician or competent person.

ª This product should be serviced by an authorized

Service Centre, and only genuine spare parts should be used.

ª Under no circumstances should you attempt to

repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts.

these should be punc tured this would damage the appliance beyond repair and cause food loss. DO NOT USE SHARP INSTR UMENTS to scrape off frost or ice. Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner . Solid ice should be allowed to thaw when defrosting the appliance. See defrost instructions.

ª Do not place carbonated or ﬁzzy drinks in the

freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance.

Installation

ª There are working parts in this product which heat

up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions.

ª Parts which heat up should not be exposed.

Wherever possible the back of the product should be against a wall.

ª If the appliance has been transported horizontally,

it is possible that the oil contained in the compressor ﬂows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to ﬂow back in the compressor.

Environment Protection

Use

ª The domestic refrigerators and freezers are

designed to be used speciﬁcally for the storage of edible foodstuffs only.

ª Frozen food must not be re-frozen once it has been

thawed out.

ª Manufacturers’ storage recommendations should

be strictly adhered to. Refer to relevant instructions.

ª The inner lining of the appliance consists of

channels through which the refrigerant passes. If

Printed on recycled paper

ª This appliance does not contain gasses which

could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the symbol are recyclable.

CONTENTS

Installation 15

ª Positionin 15 ª Cleaning the interior 15 ª Building-in instruction 16 ª Electrical connection 19

Technical speciﬁcation 19

Use 20

ª Operation 20 ª Temperature regulation 20 ª Fresh food refrigeration 20

ª Movable shelves 21 ª Positioning the door shelves 21 ª Freezing fresh food 22 ª Storage of frozen food 22 ª Thawing 22 ª Ice-cube production 22 ª Defrosting 23

Maintenance 24

ª Periodic cleaning 24 ª Periods of non-operation 24 ª Interior light 24

Customer service and spare parts

INSTALLATION

IIf this appliance featuring magnetic door seals is

to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance.

This will prevent it from becoming a death-trap for a child.

Positioning

Important

It is essential that the appliance be connected to an efﬁcient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualiﬁed electrician in accordance with existing safety regulations.

The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN).

The class of your appliance is shown on its rating plate.

For building into kitchen units follow the special “Building-in” instructions given.

The Manufacturer declines all responsibility if the above safety precautions are not observed.

This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression.

This appliance complies with the following E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directi ve) and

subsequent modiﬁcations;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent modiﬁcations.

Cleaning the interior

Before using the appliance for the ﬁrst time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the ﬁnish.

+ 9 hidden pages