Please read these user instructions carefully and
keep them to refer to later.
Please pass the user instructions on to any future
owner of the appliance.
The following symbols are used in the
text:
1 Safety instructions
Warning! Notes that concern your personal
safety.
Important! Notes that show how to avoid
damage to the appliance.
Please comply with these instructions. If you
do not, any damage resulting is not covered
by the warranty.
5 This appliance conforms with the following EU
Directives:
– 73/23/EEC dated 19.02.1973 Low Voltage Direc-
tive
– 89/336/EEC dated 03.05.1989 EMC Directive in-
clusive of Amending Directive 92/31/EEC
– 93/68/EEC dated 22.07.1993 CE Marking Directive
Correct use
• This appliance should be used only for normal domestic cooking and frying of food.
• The appliance must not be used as a work surface
or as a storage surface.
• Additions or modifications to the appliance are not
permitted.
• Do not place or store flammable liquids, highly inflammable materials or fusible objects (e.g. plastic
film, plastic, aluminium) on or near the appliance.
Child safety
• Small children must be kept away from the appliance.
• Only let older children work on the appliance under
supervision.
General safety
• The appliance may only be installed and connected by trained, registered service engineers.
• Built-in appliances may only be used after they
have built in to suitable built-in units and work surfaces that meet standards.
• In the event of faults with the appliance or damage
to the glass ceramic (cracks, scratches or splits),
the appliance must be switched off and disconnected from the electrical supply to prevent the
possibility of an electric shock..
• Repairs to the appliance must only be carried out
by trained registered service engineers.
• Cables from electrical appliances must not touch
the hot surface of the appliance or hot cookware.
• Overheated fat and oil can ignite quickly. When
cooking with fat or oil (e.g. frying chips) do not
leave the appliance unattended.
• Switch the cooking zones off after each use.
• With halogen cooking zones, do not look directly
into the halogen light, this can damage the eyes.
Safety when cleaning
• For cleaning, the appliance must be switched off
and cooled down.
• For safety reasons, the cleaning of the appliance
with steam jet or high-pressure cleaning equipment is not permitted.
How to avoid damage to the appliance
• The ceramic glass can be damaged by objects falling onto it.
• The edge of the ceramic glass can be damaged by
being knocked by the cookware.
• Cookware made of cast iron, cast aluminium or
with damaged bottoms can scratch the ceramic
glass if pushed across the surface.
• Objects that melt and things that boil over can
burn onto the ceramic glass and should be removed straightaway.
• Do not use the cooking zones with empty cookware or without cookware.
Safety during use
• Remove stickers and film from the glass ceramic.
• There is the risk of burns from the appliance if used
carelessly.
4
Description of the Appliance
w
Cooking surface layout
Single cooking zone
1200W
Single ring cooking zone
Halogen 2400W
Double ring cooking zone
700/1700W
Control panelSingle cooking zone
1200W
Control panel layout
Lock
ith pilot light
On/Off
with power indicator
Heat setting selection
Display
Timer display
Timer
Cooking zone indicators
Timer function
Second ring
On/Off
Double ring pilot light
5
Touch Control sensor fields
The appliance is operated using Touch Control sensor fields. Functions are controlled by touching sensor fields and confirmed by displays and acoustic
signals.
Touch the sensor fields from above, without covering
other sensor fields.
Sensor fieldFunction
On / OffSwitches appliance on and off
Increase settingsIncreasing heat setting/ time
Decrease settingsDecreasing heat setting/ time
TimerTimer selection
LockLocking/unlocking the control panel
Dual zone touch controlSwitches outside zone
Displays
on and off
DisplayDescription
¾ Cooking zone is switched off
u Keep warm settingKeep warm setting is set
¿ - ÇHeat settingsHeat setting is set
a Automatic warm up functionAutomatic warm-up function is activated
e FaultMalfunction has occurred
h Residual heatCooking zone is still hot
l Child safety deviceLock/child safety device is set.
_ Safety cut-outSafety cut-out has been activated
Residual heat indicator
1 Warning! Risk of burns from residual heat. Af-
ter being switched off, the cooking zones need
some time to cool down. Look at the residual
heat indicator
h.
3 Residual heat can be used for melting and
keeping food warm.
6
Operating the appliance
Switching the appliance on and off
Control panelDisplayPilot light
Switch onTouch for 2 seconds
Switch offTouch for 1 second
3 After switching on, within approx. 10 seconds
a heat setting or a function must be set, other-
Halogen cooking zone
With halogen cooking zones full heat is reached
immediately.
First place the cookware on the cooking zone and
then switch on the cooking zone.
1Important: Never look directly into the halogen
light, this can damage the eyes.
Setting the heat setting
Control panel Indicator
To increaseTouch
¾ / h lights up
h / none goes out
wise the appliance automatically switches itself off.
u to Ç
To decreaseTouch Ç to ¾
To switch offTouch and at the same time¾
Switching the double ring
cooking zone on and off
With the double ring cooking zone the heating surface can be matched to the size of the cookware.
Double ring cooking zoneSensor fieldPilot light
To switch on outside ringTouch for 1-2 secondsis lit
To switch off outside ringTouch for 1-2 secondsgoes out
7
Using the automatic warm-up function
All cooking zones are equpped with an automatic
warm up function When setting a heat setting using
, when starting from
to full power for a certain amount of time and then
automatically switches back to the heat setting set.
¾, the cooking zone switches
Control panel possible heat set-
tings
Switch on
(only when starting at
Switch offTouch
Not usedTouch Ç to uÇ to u
¾)
Touch
¿ to Æa (after 5 seconds)
Æ to¿ / uÆ to u
Display
3 If during the automatic warm up a a higher
heat setting is selected, e.g. from
automatic warm up is adjusted.
Á to Ã, the
3 If there is still residual heat on the cooking
zone (display
not performed.
The length of time that the automatic warm up function operates depends on the heat setting selected.
Heat
setting
v0:30
11:00
21:402.2:40
h), the automatic warm up is
Length of the automatic warm
up [min:sec]
Intermediate
heat setting
Length of the automatic warm
up [min:sec]
34:503.5:30
46:304.8:10
510:105.12:20
62:006.2:30
73:30
84:30
9---
Locking/unlocking the control panel
The control panel, with the exception of the “On/Off”
sensor field, can be locked at any time in order to
prevent the settings being changed e.g. by wiping
over the panel with a cloth.
Control panelDisplay
Switch onTouch
Switch offTouch previously set heat setting
l (for 5 seconds)
3 When you switch the appliance off, the locking
function is automatically switched off.
8
Using the child safety device
The child safety device prevents unintentional use of
the appliance.
Setting the child safety device
Step Control panel Display/Signal
1. Switch on the appliance
(Do not set a heat setting)
2.Touch until the signal soundsAcoustic signal
3.Touch
Appliance switches off. The child safety device is engaged.
¾
l
Releasing the child safety device
Step Control panel Display/Signal
1.
2.Touch until the signal soundsAcoustic signal
3.Touch
Appliance switches off. The child safety device is released.
Switch on the appliancel
Overriding the child safety device
The child safety device can be released in this way
for a single cooking session; it remains activated afterwards.
StepControl panelDisplay/Signal
1. Switch on the appliance
2.Touch and at the same time
Until the appliance is next switched off, it can used as normal.
l
¾ / acoustic signal
3 After overriding the child safety device, a heat
setting or a function must be set within
approx. 10 seconds, otherwise the appliance
automatically switches itself off.
9
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.