Zanussi ZH280B, ZH280W User Manual

INSTRUCTION BOOKLET

INTEGRATED

COOKER HOOD

ZH 280

Thank you for buying a Zanussi product.

To enable you to use your appliance effectively and safely, please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further information on Zanussi Products, please contact our Customer Care Department. For general enquiries concerning your Zanussi appliance or for further information, visit our website at http:\\www.zanussi.co.uk

Customer Care Department Zanussi 55-77 High Street Slough Berkshire Tel: 08705 727727(*) SL1 1DZ Fax: 01753 538972

* calls to this number may be recorded for training purposes.

To register ownership, please ensure you complete and return the guarantee card supplied with the appliance.

For the User

For the Installer

Important Safety Information

Your Appliance

Operating Instructions

Cooker Hood Controls To Operate Extraction mode Recirculation

Maintenance and Cleaning

External Cleaning Synthetic Paper Grease Filter To Replace the Synthetic Paper Grease Filter Charcoal Filter (Optional Extra) To Remove the Charcoal Filter Changing the Light Bulb

Something Not Working

Service and Spare Parts

Guarantee Conditions

Guide to use the instruction book

The following Symbols will be found in the text to guide you through the instruction book

Installation Instructions

Technical Information

Electrical Connections

Electrical Requirements Electrical Connection

Installing the Cooker Hood

Installation Requirements Ducting Clearance Height Unpacking The fixing kit comprises Fitting the Wall Brackets Venting To Fit the Ducting Recirculation Fitting the Cooker Hood to the Wall Decor Panel Fitting a Decor Panel to the Hood Visor To Refit the Hood With Decor Panel Attached Adjustment

Safety instructions Step by step instructions

IMPORTANT SAFETY INFORMATION

These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department.

Installation

• Any installation work must be undertaken by a qualified electrician or a competent person.

• This hood must be installed in accordance with the installation instructions and all measurements must be adhered to.

• If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Codes of Practice BS.6172, BS.5440 and BS.6891 (Natural Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation & Use) Regulations, the Building Regulations issued by the Department of the Environment, the Building standards (Scotland) (Consolidated) Regulations issued by the Scottish Development Department.

• The fan motor of this cooker hood incorporates a cutout device which will operate if the cooker hood is installed below the minimum height recommended under section ‘Clearance Height’, or if the motor becomes overheated. If the cut-out device is activated, switch off the fan motor and allow the cooker hood to cool. The cut-out device will reset itself when the fan motor has cooled significantly.

• It is dangerous to alter the specifications or modify this product in any way.

• When installed between adjoining wall cabinets the wall cabinets must not overhang the hob.

Child Safety

• This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance.

During Use

• This product is for domestic use only.

• Never leave frying pans unattended during use as over-heated fats and oils might catch fire.

• Never do flambé cooking under this cooker hood.

• Do not leave naked flames under the hood.

Maintenance and Service

• This appliance can be a hazard if the synthetic paper and charcoal filters are not replaced as recommended.

• Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Zanussi Service Force Centre. Always insist on genuine spare parts.

• If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type.

• If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.

• The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose.

• Do not install above a cooker with a high level grill.

YOUR APPLIANCE

OPERATING INSTRUCTIONS

This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.

To obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing.

Cooker Hood Controls

S. Automatic Microswitch

The microswitch overrides the controls, and switches off the hood when the visor is closed. When the visor is opened the hood will resume the function of previoussetting.

M. Fan Speed Control

Position 0 - Off Position 1 - Low Position 2 - Normal Position 3 - Boost

L. Light ON/OFF control

To Operate

Open the visor and select the required functions.

Extraction

The contaminated air enters the hood passing through the grease filter and out through the ducting into the

atmosphere.

Recirculation

A charcoal filter is available as an optional extra, which enables the cooker hood to recirculate the air back into the kitchen.

When the extraction mode is selected the charcoal filter is not required.

Never do flambé cooking under this cooker hood.

Take extra care when frying and never leave frying pans unattended during use, as overheated fats and oils can catch fire.

Do not leave naked flames under the cooker hood.

Ensure the visor is open when using the hob, even if the fan on the hood is not switched on.

Ensure heating areas on your hob are covered with pots and pans when using the hob and cooker hood simultaneously.

Extraction Mode

Recirculation Mode

MAINTENANCE AND CLEANING

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.

The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard.

External Cleaning

Wipe the cooker hood frequently with warm soapy water using a mild detergent.

Always wear protective gloves when cleaning the hood.

Never use scouring pads or abrasive cleaners.

Never use excessive amounts of water when cleaning particularly around the control panel.

Synthetic Paper Grease Filter

The filter has saturation indicators, which are small squares made from a series of dots. When the white paper inside the squares becomes saturated with grease the coloured dots start to run and spread across the paper, indicating that the filter has reached saturation point and must be replaced.

To replace the synthetic paper grease filter

1. Open the visor.

2. Press inwardly on the two slide catches and lower

the grille to the stop position. Raise the front edge of the grille through a 45° angle until it detaches itself from the guides.

3. Carefully ease out the metal wire retaining clips.

4. Clean the metal grille and clips before replacing

the grease filter.

Handle the wire clips with care and keep away from children as they have sharp points.

The synthetic paper grease filter cannot be cleaned.

It must not be washed.

Charcoal Filter (Optional Extra for use in recirculation mode)

The charcoal filter cannot be cleaned, it should be replaced approximately every three months or more often if the hood is used for more than three hours per day.

To Remove the Charcoal Filter

1. Remove the thumb screw through the center of

the charcoal filter, from the motor support.

2. The charcoal filter can now be removed.

This appliance can be a fire hazard if the grease and charcoal filters are not replaced as recommended.

Changing the Light Bulb

The bulb should be replaced with a 220-240 volt 40 watt clear cylindrical shape bulb with a small (E14) screw thread.

Replacement charcoal filters, grease filters and light bulbs can be obtained from your local Service Force Centre.

+ 14 hidden pages