Zanussi ZGS646X User Manual

GAS HOB

ZGS 646X

INSTRUCTION BOOKLET

Please read this instruction booklet before using the appliance

UA RO EE KZ

LV LT

Important safety information

These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance.

About Installation, Cleaning

and Maintenance

It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations.

Ensure a good ventilation around the appliance. A poor air supply could cause lack of oxygen.

Ensure that the gas supply complies with the gas type stated on the identification label, placed near the gas supply pipe.

Using a gas cooking appliance will produce heat and moisture in the room which it has been installed in. Ensure a continuous air supply, keeping the air vents in good conditions or installing a cooker hood with discharge tube.

In case of intensive or long time use of the appliance, make the ventilation more efficient, by opening a window or increasing the electric exhaust fan power.

Once you removed all packaging from the appliance, ensure that it is not damaged. Otherwise, contact your dealer before proceeding with the installation.

The manufacturer disclaims any responsability should all the safety measures not be carried out.

Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Refer to your local Service Centre. Always insist on genuine spare parts.

During Operation

It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings.

Thisappliance hasbeendesignedfornonprofessional purpose in private houses only. It is meant to cook ediblefoodstuffonlyandMUST NOT beusedforanyother purposes.

It is dangerous to alter the specification in any way.

Forhygieneandsafety reasons,thisappliance should be kept clean at all times. A build-up of fats or other foodstuff could result in a fire.

Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Refer to your local Service Centre. Always insist on genuine spare parts.

Ensure that all control knobs are in the OFF position when not in use.

Never use steam or steam machines to clean the appliance.

Child Safety

This appliance has been designed to be operated by adultsandchildrenundersupervision.Youngchildren MUST NOT be allowed to tamper with the controls or play

near or with the oven.

This appliance is not intended for use by children or other persons whose physical, sensory or mental capabilities or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person to ensure that they can use the appliance safely.

Accessible parts of this appliance may become hot when it is in use. Children should be KEPT AWAY until it has cooled.

Environmental Information

After installation, please dispose of the packaging with due regard to safety and the environment.

The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

These instructions are only for the countries stated by the symbol printed on the front cover of this instruction book.

2

Contents

For the User

 

For the Installer

 

Important safety information

2

Instruction for the Installer

6

Instruction for the User

4

Technical data

6

Cleaning and Maintenance

5

Gas connection

7

Service and original spare parts

11

Adaptation to different types of gas

8

European guarantee

11

Building In

9

 

 

Possibilities for insertion

10

Guide to Use the instructions

Thefollowingsymbolswillbefoundinthetexttoguideyou throughout the Instructions:

Safety Instructions

Step by step instructions for an operation

Hints and Tips

Environmentalinformation

This appliance complies with the following

E.E.C. Directives:

-2006/95 (Low Voltage Directive);

-89/336 (Electromagnetical Compatibility Directive);

-90/396 (Gas Appliances);

-93/68(General Directives) and subsequent modifications.

MANUFACTURER:

ELECTROLUX HOME PRODUCTS ITALY S.p.A.

Viale Bologna, 298

47100 FORLÌ (Italy)

3

Zanussi ZGS646X User Manual

Instruction for the User

Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory.

Hob burners control knobs

The hob burners control knobs are situated on the hob right hand side. The symbols on the knobs mean that:

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

To light a burner:

1.push in the relevant knob and turn it anticlockwise to "maximum position".

2.Hold a flame near the burner.

3.Then, check the flame is regular and adjust it as required.

Ifyoucannotlighttheflameevenafterseveralattempts, check the "cap" (Fig. 1, lett. A) and the "crown" (Fig. 1, lett. B) are in the correct position.

To put the flame out, turn the knob to the symbol .

Always turn the flame down or put it out before taking the pans off the burner.

In the absence of electricity, ignition can occur without the electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the "maximum" position.

Do not keep the control knob pressed for more than 15 seconds.

If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position and wait for at least one minute before trying to light the burner again.

Using the hob correctly

To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (see the table beside) (Fig. 2).

It is also advisable, as soon as a liquid starts boiling, to turn down the flame so that it will barely keep the liquid simmering.

Use only pans or pots with flat bottom.

Carefully supervise cookings with fats or oil, since these types of foodstuff can result in a fire, if over-heated.

Fig. 1

A - Burner cap

B - Burner crown

C - Burner body

Burner

 

minimum

maximum

 

 

 

diameter

 

diameter

 

 

 

 

 

 

 

 

 

Large(rapid)

 

 

180 mm

 

260 mm

Medium (semirapid)

 

 

120 mm

 

220 mm

Small (auxiliary)

 

 

80 mm

 

160 mm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Fig. 2

4

Cleaning and Maintenance

General cleaning

Wash the enamelled components with warm soapy water. Never use abrasive cleaners

Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food.

Regularly wipe over the hob top using a soft cloth weel wrung out in warm water to which a little liquid detergent has been added. Avoid the use of the following:

-household detergent and bleaches;

-impregnated pads unsuitable for non-stick saucepans;

-steel wool pads;

- bath/sink stain removers.

Should the hob top become heavily soiled, it is recommended that a proper cleaning product is used.

Fig. 3

Pan supports

The pan supports are dishwasher proof.

If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products.

Never use steel wool pads or acids.

The Burners

The burner caps and crowns (Fig. 1) can be removed for cleaning. Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cloth.

Periodic Maintenance

Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted.

5

Loading...
+ 11 hidden pages