This new appliance is easy to use. Nevertheless, it is important to carefully read this
booklet before installing or using the appliance for the first time. This will allow you to
obtain best performance, avoid improper actions, use the appliance in complete safety
and also respect the environment.
If you need assistance, contact our Customer Care Department on
08705 727 727.
Installation
This appliance must be installed and
serviced by a competent person as stated
in the Gas Safety ( Installation and Use)
Regulations Current Editions and the IEE
Wiring Regulations.
For appliances installed in the Republic
of Ireland please refer to NSAI-Domestic
Gas Installations I.S.813 Current
Editions and the ETCI Rules for
Electrical Installations.
Installation of the appliance and
connection to the power supply must
only be carried out by QUALIFIED
PERSONNEL. Before any intervention,
make sure the appliance is
DISCONNECTED from the power
supply.
Ensure that air can freely circulate
around the appliance. Poor ventilation
produces a lack of oxygen.
Ensure that the gas and electrical supply
complies with the type stated on the
rating plate, located below the front edge
of the glass top.
This appliance is not connected to a
combustion products evacuation device.
It must be installed and connected in
accordance with current installation
regulations. Particular attention shall be
given to the relevant regulations regarding
ventilation.
When in use a gas cooking appliance
will produce heat and moisture in the
room in which it has been installed.
Ensure there is a continuous air supply,
keeping air vents in good condition or
4
installing a cooker hood with a venting
hose.
When using the hob for a long period
time, the ventilation should be improved,
by opening a window or increasing the
extractor speed.
After unpacking the appliance, make
sure the product is not damaged and that
the power cable is in perfect condition.
Otherwise, contact the dealer before
installing the appliance.
The manufacturer declines any liability
should these safety measures not be
observed.
Child Safety
This hob is designed to be operated by
adults. Do not allow children to play near
or with the hob. It is highly
recommended to activate the child safety
function every time the hob is not
operated.
The hob gets hot during use and some
time after it is switched off. The hob is
supplied with special indicators for the
residual heat (see chapter “How to light
a burner”). Children should be kept away
from the appliance until it has cooled
down and the residual heat indicators
are off.
During use
This instruction booklet must be kept
with the appliance for any future
reference. If the appliance is sold or
transferred to another person, ensure the
booklet is passed on to the new user.
This hob is intended for domestic cooking
only. It is not designed for commercial
or industrial purposes.
It is dangerous to modify or try to modify
the characteristics of this product.
Keep the appliance clean. Food residuals
increase the risk of fire.
This appliance cannot be cleaned with
steam or with a steam cleaning machine.
In case of malfunctions, never attempt
to repair the appliance on your own.
Repairs carried out by unqualified
persons can cause damage and
accidents. Refer to the contents of this
booklet (see chapter “Something not
working”). If you do not find the
information required, contact the nearest
Service Force Centre. Servicing of this
appliance must be carried out by an
authorised Service Engineer.
Always insist on genuine spare parts.
After using the appliance, deactivate it
by using the main ON/OFF touch control
and make sure the relevant red indicator
is off. Then, lock all the hob controls by
touching the “Lock” Control .
When using other electrical appliances,
ensure the cable does not come into
contact with the hot surfaces of this
cooking appliance.
Environmental Information
All the materials used are environment
friendly and recyclable. Please make
your contribution to safeguarding the
environment by using the special
differentiated collection channels.
Dismantled or no longer used appliances
are not worthless waste. Through
ecological disposal, various materials
used in the production of your appliance
can be recycled.
Find out about the current possibilities
of disposal from your specialised dealer,
or from your local Council.
When disposing of an old appliance,
make it unusable, by cutting off the
cable.
The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it shall be handed over to the applicable
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will
help prevent potential negative
consequences for the environment and
human health, which could otherwise be
caused by inappropriate waste handling of
this product. For more detailed information
about recycling of this product, please
contact your local city office, your
household waste disposal service or the
shop where you purchased the product.
Guide to Use the instructions
The following symbols will be found in the
text to guide you throughout the
Instructions:
Safety Instructions
Step by step instructions for an
operation
Hints and Tips
Environmental Information
These instructions are only valid for countries whose identification symbols are
given on the cover of the instruction booklet and on the appliance.
5
Description of the hob
Timer control
zone
Rear left
burner
control
zone
Front left
burner
control zone
Semirapid
burner
Auxiliary
burner
Semirapid
burner
Rapid
burner
Child
Safety
Control
Main
ON/OFF
switch
Rear right
burner
control
zone
Front right
burner
control zone
6
Operating instructions
Before using the appliance,
remove all packaging, including
the advertising labels and any
protective film.
Touch Controls
The hob is supplied with special Touch
Controls. To operate your hob, simply touch
the required control with a fingertip.
Ensure to only touch one control at a time
during use.
Here follow the symbols for the main Touch
Controls, and the relevant indicators
Main ON/OFF Touch Control
Burner Ignition Touch Control
Flame level indicators
Increasing Touch Control for the flame
level
Decreasing Touch Control for the
flame level
Residual heat indicator
Burner
control zone
7
How to light a burner
1. Touch the main ON/OFF Control for
about 3 seconds to switch on the hob.
The red indicator above the touch control
lights up, an acoustic signal sounds and
the hob is ready to use.
2. Touch the Burner Ignition Touch Control
of the required burner. The flame
level indicators located right above the
symbols and illuminate.
3. Within about 3 seconds, touch the
Increasing or Decreasing Touch
Control to light the burner.
- If touch control is selected, the
burner automatically lights at maximum
flame level (all the flame level indicators
illuminate).
8
- If touch control is selected, the
burner automatically lights at medium
flame level (three flame level indicators
illuminate).
4. To adjust the burner flame level, use the
Increasing or Decreasing Touch
Control.
The residual heat indicator lights up
immediately after the burner is lit.
This means that the cooking zone is
getting hot: the indicator remains on until
the pan support and the burner have
cooled down.
How to turn off a burner
1. To turn off a burner press the relevant
Burner Ignition Touch Control. All the
flame level indicators go off.
The residual heat indicator remains on
until the pan support and the burner have
cooled down.
In case of ignition failure
The hob ignition device generates a series
of small sparks for about 6 seconds.
If the flame does not light during this period,
the gas flow to the burner is interrupted.
After 3 seconds, the ignition device
automatically repeats the ignition procedure
for another 6 seconds.
After three failed ignition attempts, a safety
device is set on the burner. The flame level
indicators flash.
Caution! When the safety device is
set on a burner, the burner controls
cannot be operated for about 60
seconds.
9
After 60 seconds, you can remove the
safety device on the burner by touching both
the Increasing Controls and the
Decreasing Control at the same time.
Then, follow the instructions given in the
paragraph “How to light a burner”.
Caution! Check that the burner cap
is correctly positioned (see diagram).
If the ignition problem persists, refer
to chapter “Something not working”.
Never use a manual spark gas-lighter
if the burner ignition device does not
work correctly. If necessary, use a
match.
In case of accidental
extinguishing (automatic
reignition)
If the burner flame is accidentally extinguished
(draughts, spilling of liquids, etc.), the gas
flow is immediately interrupted.
After about 20 seconds,
automatically repeats the ignition procedure
Upon reignition, the burner flame is first set
at maximum level, then it is automatically
adjusted to the level set before it was
accidentally extinguished.
If three consecutive reignition attempts fail,
a safety device is set on the burner. The
flame level indicators and the residual heat
indicator flash.
Caution! When the safety device is
set on a burner, the burner controls
cannot be operated for about 60
seconds.
the ignition device
Burner
Cap
Spark
plug
Thermocouple
.
After 60 seconds, you can remove the
safety device on the burner by touching both
the Increasing Controls and the
Decreasing Control at the same time.
Then, follow the instructions given in the
paragraph “How to light a burner”.
10
How to turn off all the
burners at once
In case of unexpected safety hazard (spilling
of liquids, children hazard, etc.), you can
immediately turn off all the hob burners at
once by touching the main ON/OFF
Control.
Burner Safety Cut-off
Function
If you leave one or more burners lit and
unattended for a long time (that is, you don’t
touch any control for at least 4 hours), each
lit burner is automatically turned off and a
safety device is set on it.
If you select the burner that doesn’t
work with the Timer Control Codenumber 10 flashes in the cooking
time display.
Caution! When the safety device is
set on a burner, the burner controls
cannot be operated for about 60
seconds.
After 60 seconds, you can remove the
safety device on the burner by touching both
the Increasing Controls and the
Decreasing Control at the same time.
Then, follow the instructions given in the
paragraph “How to light a burner”.
Hob Safety Cut-off
Function
If no burner is on but the hob is activated
(the red indicator above the touch control
is on), the hob is automatically switched
off if no control is operated within 30
minutes.
11
Protection against
overheating
If the hob is used intensively, e.g. several
burners at maximum level for a long time, a
temperature sensor detects possible
overheating and automatically adjusts all
the lit burners to minimum.
If the hob temperature keeps rising although
the flame level has been reduced, all the lit
burners are automatically turned off and a
safety device is set on all the four burners.
If you select all the burners with the
Timer Control (one at a time)
Code number 9 flashes in the
cooking time display.
Caution! When the safety device is
set on all the burners, their controls
cannot be operated for about 60
seconds.
After the 60 seconds, you can reactivate
all the burners by touching the Increasing
Control and the Decreasing Control of
one of the four burners at the same time.
Once the safety device has been removed,
wait until the hob has cooled down before
using it again.
Child Safety Function
To avoid children operating the hob controls,
it is possible to lock them.
1. Touch the “Lock” Control for about 3
seconds. The red indicator next to the
“Lock” symbol lights up and an
acoustic signal sounds.
Now all the hob controls are locked, except
the main ON/OFF Touch Control.
Any lit burner keeps operating, but cannot
be adjusted.
12
Loading...
+ 28 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.