Zanussi ZGF 982 User Manual

GAS HOB

ZGF 982

INSTRUCTION BOOKLET

Please read this instruction booklet before using the appliance

Important Safety Information

Installation

You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on

08705 727727

z This appliance must be installed and serviced by a

competent person as stated in the Gas Safety (Installation and Use) Regulations Current Editions and the IEE Wiring Regulations.

z Remove all packaging before using the hob. z Ensure that the gas and electrical supply complies

with the type stated on the rating plate, located near the gas supply pipe.

z Do not attempt to modify the hob in any way.

Child Safety

z This hob is designed to be operated by adults. Do

not allow children to play near or with the hob.

z The hob gets hot when it is in use.

z Children should be kept away until it has cooled.

z Children can also injure themselves by pulling pans

or pots off the hob.

z This appliance is not intended for use by children or

other persons whose physical, sensory or mental capabilities or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person to ensure that they can use the appliance safely.

z Unstable or misshapen pans should not be used on

the hob as unstable pans can cause an accident by tipping or spillage.

z Never leave the hob unattended when cooking with

oil and fats.

z Never use plastic or aluminium foil dishes on the hob.

z Perishable food, plastic items and areosols may be

affected by heat and should not be stored above or below the hob unit.

Service

z This hob should only be repaired or serviced by an

authorised Service Engineer and only genuine approved spare parts should be used.

During Use

z This hob is intended for domestic cooking only. It is

not designed for commercial or industrial purposes.

z This appliance is not connected to a combustion

products evacuation device. It must be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation.

z When in use a gas cooking appliance will produce

heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose.

z When using the hob for a long period time, the

ventilation should be improved, by opening a window or increasing the extractor speed.

z Do not use this hob if it is in contact with water.

Do not operate the hob with wet hands.

z Ensure the control knobs are in the ‘OFF’ position

when not in use.

z When using other electrical appliances, ensure the

cable does not come into contact with the hot surfaces of the cooking appliance.

Content s

For the User

Important Safety Information 2

Description of the Hob 4

Operation 5

Maintenance and Cleaning 6

Something Not Working? 7

Guarantee/Customer Service 16

European guarantee 17

For the Inst aller

Instructions for the Installer 8

Important safety requirements 9

Installation 10

Building In 11

Electrical connections 12

Wiring Diagram 13

Fault Finding 13

Commissioning 15

Conversion from Natural Gas to LPG 15

Environmental Information

z After installation, please dispose of the packaging

with due regard to safety and the environment.

z When disposing of an old appliance, make it unusable,

by cutting off the cable.

z The symbol on the product or on its packaging

indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Keep this instruction book for future reference

and ensure it is passed on to any new owner.

Guide to Use the instructions

The following symbols will be found in the text to guide you throughout the Instructions:

Safety Instructions

))

)

))

Step by step instructions for an operation

Hints and Tips

Environmental Information

This appliance complies with the following

E.E.C. Directives: * 73/23 - 90/683

(Low VoltageDirective);

* 93/68 (General Directives); * 89/336 (Electromagnetical Compatibility Directive); * 90/396 (Gas Appliances),

and subsequent modifications

Description of the Hob

1. Auxiliary Burner

2. Semi-rapid Burners

3. Ultra-rapid Triple-crown Burner

4. Rapid Burner

5. Control knobs

Operation

Hob burners

To light a burner:

))

)

))

z turn the relevant control knob anticlockwise to the

maximum position, then push it down to ignite the burner;

z then, check the flame is regular and adjust it as

required. If you cannot light the flame even after several attempts, check the "cap" and “crown” (see Fig. 1 - letter A and B) are in the correct position. To put the flame out, turn the knob to the symbol z.

When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).

Triple-crown Burner

Burner minimum maximum

diameter diameter

Ultra-rapid (triple-crown) 180 mm 260 mm Large (rapid) 180 mm 260 mm Medium (semi-rapid) 120 mm 220 mm Small (auxiliary) 80 mm 160 mm

If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.

Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.

As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.

If the control knobs become difficult to turn, please contact your local Service Force Centre.

Fig. 1

A - Burner cap B - Burner crown C - Ignition electrode

Using the Wok Stand

A wok stand is provided to enable you to use a round bottomed wok on the hob. The wok stand must only be used on the central burner, and should not be used with any other type of wok or pan. When fitting the wok stand, ensure the recesses in the frame fit securely onto the bars of the pan supports, as shown in the diagram.

Maintenance and Cleaning

Before any maintenance or cleaning can be carried

out, you must DISCONNECT the hob from the

electricity supply.

The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.

The Hob Top

Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. Avoid the use of the following:

- household detergent and bleaches;

- impregnated pads unsuitable for non-stick saucepans;

- steel wool pads;

- bath/sink stain removers. Should the hob top become heavily soiled, it is recommended that a cleaning product such as Hob Brite or Bar Keepers Friend is used.

The Burners

The burner caps and crowns can be removed for cleaning. Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cloth.

Ignition electrode

The electric ignition is obtained through a ceramic and metal electrode (Fig. 1 - letter C). Keep these components very clean, to avoid lighting difficulties, and check that the burner crown holes are not obstructed.

+ 14 hidden pages