Zanussi ZCE631X User Manual
ELECTRIC
COOKER
ZCE 631
INSTRUCTION BOOKLET
GB
Please read this instruction booklet before using the appliance
Important Safety Information
You MUST read these warnings carefully before installing or using the appliance. If you need
assistance, contact our Customer Care Department on 08705 727727
Installation
l This cooker must be installed by qualified personnel,
according to the manufacturers instructions and to
the relevant British Standards.
This cooker is heavy. Take care when moving it.
l Remove all packaging before using the cooker.
l Ensure that the electrical supply complies with the
type stated on the rating plate.
l Do not attempt to modify the cooker in any way.
l Perishable food, plastic items and areosols may be
affected by heat and should not be stored above the
cooker.
Service
l This cooker should only be repaired or serviced by an
authorised Service Engineer and only genuine
approved spare parts should be used.
Child Safety
l This cooker is designed to be operated by adults. Do
not allow children to play near or with the cooker.
l The cooker gets hot when it is in use. Children should
be kept away until it has cooled.
l Children can also injure themselves by pulling pans
or pots off the cooker.
During Use
l This cooker is intended for domestic cooking only. It
is not designed for commercial or industrial purposes.
l Do not use this cooker if it is in contact with water.
Do not operate the cooker with wet hands.
l Ensure the control knobs are in the OFF position
when not in use.
l When using other electrical appliances, ensure the
cable does not come into contact with the hot surfaces
of the cooker.
l Never use the ceramic hob as a working space. Do
not store things on the ceramic hob.
l Never use plastic or aluminium foil dishes on the
ceramic hob.
l Unstable or misshapen pans should not be used on
the ceramic hob as unstable pans can cause an
accident by tipping or spillage.
l Never leave the cooker unattended when cooking with
oil and fats.
l The ceramic hob is shockproof, but not unbreakable!
Hard or pointed objects falling from a height can
damage the hob. If scratches or cracks are noticed,
disconnect the cooker from the electrical supply and
call you nearest Zanussi Service Force Centre.
l This cooker should be kept clean at all times. A
build-up of fats or foodstuffs could result in a fire.
l Never use plastic dishes in the oven.
part of the oven with aluminium foil.
l Always ensure that the oven vent which is located at
the centre back of the hob is left unobstructed to
ensure ventilation of the oven cavity.
Never line any
Environmental Information
l After installation, please dispose of the packaging with
due regard to safety and the environment.
l When disposing of an old appliance, make it unusable,
by cutting off the cable.
Keep this instruction book for future
reference and ensure it is passed on
to any new owner.
Guide to Use the instructions
The following symbols will be found in the text to guide
you throughout the Instructions:
Safety Instructions
Step by step instructions for an operation
F
Hints and Tips
Environmental Information
This appliance is manufactured according to
the following EEC directives:
73/23 EEC - 90/683 EEC - 93/68 EEC 89/336 EEC current edition.
2
Contents
For the User
Important Safety Information 2
Description of the Cooker 3
Control Panel 4
Operation 5
Using the ceramic glass hob 6
Electric Oven 7
Before the First Use of the Cooker 7
24 hour Clock and Timer 8
Using the Conventional Oven 11
The Fan Oven 13
Defrosting 14
Grilling 15
Cleaning the Ceramic Hob 16
Cleaning the Oven 17
Something not working 18
Service and Spare Parts 19
For the Installer
Important Safety Requirements 21
Instructions for the Installer 21
Electrical connections 22
Oven Door Protection Device
All our appliances comply with the European safety
standards. Nevertheless, in order to ensure the
highest safety level, and avoid small children to be
exposed to the heat when the appliance is operated,
it is possible to fit a special ptotection device to the
oven door. This device can be purchased in our
Service Force Centres, specifying the relevant code
(35791) and the Product No. shown on the rating
plate.
Customer Care Department 19
Guarantee Conditions 20
Description of the Cooker
Residual heat indicators
Back left cooking zone
Front left cooking zone
(double circuit)
A
U
T
O
Control panel
Shelf
TIMER
Back right cooking zone
(double circuit)
Front right cooking zone
Oven door
Storage drawer
3
Control Panel
2
MAINS ON
THERMOSTAT
FRONT LEFT BACK LEFT BACK RIGHT
1 3
1. Oven Thermostat Pilot Light
2. Cooker Operation Pilot Light
3. Front left cooking zone control knob
4. Back left cooking zone control knob
5. Back right cooking zone control knob
6. Front right cooking zone control knob
7. Oven function control knob
8. Oven thermostat control knob
9. 24 hour clock and Programmer
FRONT RIGHT OVEN FUNCTION TEMPERATURE
87654
Storage Drawer
The storage drawer is located underneath the oven cavity.
During cooking the storage drawer may become
hot if the oven is on high for a long period of time,
therefore flammable materials such as oven gloves,
tea towels, plastic aprons etc. should not be
stored in the drawer.
Oven accessories such as baking sheets, will also
become hot, therefore care should be taken when
removing these items from the drawer whilst the
oven is in use or still hot.
OVEN PROGRAMMER
A
U
T
O
TIMER
9
The Oven Cavity
Grill element
Oven fan
4
Oven Light
Accessories
Grill/roasting pan
Grill trivet
Removable
handles
Operation
Ceramic hob cooking zones
To switch on a cooking zone, turn the relevant control
knob clockwise to the required heat setting.
The control knob is numbered 0 - 3
0 - OFF
3 - Maximum.
The hob has two types of cooking zones:
2 normal cooking zones (back left and front
right)
We recommend the plates are switched to maximum (3)
for a short while to boost the cooking zone, and then
adjusted to the required setting.
2 double circuit cooking zones (back right and
front left)
The back right and front left cooking zones have two
heating elements.
- To switch on the smaller circular cooking zone, turn
the relevant control knob clockwise to the required
heat setting.
- To switch on both heating elements, turn the control
knob clockwise to maximum heat setting (3) then
turn the knob further to nearly reach the "0" symbol.
You will hear a "click" and the wider cooking zone
will switch on.
Then turn back the knob to position 3 and adjust
it to the required heat setting.
Please be aware that the two heating elements will now
operate together, giving a higher power output than a
normal cooking zone.
Control knob for normal cooking zone
0
3
1
2
FO 2086
Control knob for double circuit cooking zone
0
3
1
2
Residual heat indicators
The hob is fitted with four residual heat indicators
corresponding to each cooking zone.
The corresponding indicator will remain on until the
temperature falls below 30° C, even after the cooking zone
is switched off.
When switch on a cooking zone, a short buzzing
may be heard. This is quite normal and does
not affect the hob operation in any way.
Suggestions for the correct setting of the cooking zones
are given in the following table.
OFF 0
Very Gentle Simmering vegetables
Fish in its own juice
Gentle 1 Simmering potatoes or soups
Slow Boiling large quantities
of food, stews and soups
Medium 2 Slow frying, making a sauce
High Fast frying of meat or fish
Fast 3 Rapid heating up of fat or water
5
Using the ceramic glass hob
Ceramic glass surface
The glass is hard, and has been tempered to withstand
heat, cold and temperature shocks. But like all glass it
is sensitive to impact. Do not stand on the ceramic glass
surface.
If scratches or cracks are noticed, disconnect
the cooker from the electrical supply and call
you nearest Service Force Centre.
Keep all objects and materials which can melt
away from the cooking surface, e.g. plastics,
aluminium foil.
Care should be taken when preparing food or drinks
containing sugar. If anything of this nature
accidentally comes into contact with the ceramic
surface it must be scraped off immediately while
stlll hot and wiped away to avoid damage to the
surface.
Energy consumption
To save energy, you should . .
- use only cooking and frying utensils with smooth, flat
bases.
- place pots and pans in position before switching on
the cooking zone.
- wherever possible, cover pots and pans with a lid.
- switch off the cooking zone a few minutes before the
end of the cooking time, in order to make use of the
residual heat.
- use the residual heat of the cooking zones for keeping
food warm or for melting.
- position pots and pans centrally on the cooking zones.
Saucepans and frying pans
Saucepans and frying pans should not be smaller than
the cooking zone, and preferably not more than 10-15
mm larger than the diameter of the cooking zone.
Always use cooking and frying utensils with smooth, flat
bases.
The bases should always be clean and dry. Cook with a
lid in place.
Check that the bases of utensils are smooth and
undamaged; bases with burrs and sharp edges will
scratch the ceramic glass surface.
To avoid scratching or damaging the ceramic cooking
surface, pots and pans should be moved on the plate by
lifting them, and not by sliding.
Utensils with aluminium and copper bases can leave
behind metallic discolourations which can only be
removed with difficulty or sometimes not at all.
6
Electric Oven
Oven Function Control Knob
Conventional cooking - The heat comes from
both the top and bottom element, ensuring even
heating inside the oven.
Bottom heating element - The heat comes from
the bottom of the oven only
Top heating element - The heat comes from
thetop of the oven only
Grill - The heat comes only from the top element
Fan cooking - This function allows you to roast
or roast and bake simultaneously using any
shelf.
Defrost setting -This function assists in thawing
of frozen food.
Thermostat Control Knob
Turn the thermostat control knob clockwise to select
temperatures between 50°C and 250°C (MAX).
Mains On Light
0
FO 2494
50
The mains on light will come on when any function (oven
or hob) is selected.
100
Thermostat Control Light
The thermostat control light will come on when the
thermostat control knob is turned. The light will remain on
until the correct temperature is reached. It will then cycle
on and off to show the temperature is being maintained.
150
FO 0877
200
Before the First Use of the Cooker
Remove all packaging, both inside and outside
the oven, before using the oven.
Before first use, the oven should be heated without food.
During this time, an unpleasant odour may be emitted.
This is quite normal.
l Set the electronic programmer to manual
F
This procedure should be repeated with the fan cooking
and grill function for approximately 5-10 minutes.
function.
l Switch the oven function control knob to
conventional cooking .
l Set the thermostat control knob to MAX.
l Open a window for ventilation.
l Allow the oven to run empty for approximately
45 minutes.
Using the ceramic hob for the
first time
The cooking surface should be cleaned before use to
remove any traces of the production process.
Wipe the ceramic surface and frame with a damp
F
cloth using warm water to which a little washing
up liquid has been added, and wipe dry.
Heating up for the first time
To check the cooking zones, briefly switch each
F
one on.
7
24 hour Clock and Timer
Minute minder
Cooking duration
End of cooking time
Manual function
Cookpot symbol - This will be displayed when a
programme is in operation.
A
Auto symbol - This will be displayed when the
U
oven has been programmed for automatic
T
operation.
O
Time setting knob - Turn it clockwise and hold it in
the turned position to increase the time setting.
Turn it anticlockwise and hold it in the turned
position to decrease the time setting. The countup or count-down speed increases the longer the
knob is held in the turned position.
The electronic timer can indicate the time of day, operate
as a minute minder and automatically operate the oven.
Before the oven can be operated, the time of day must
be set on the electronic timer.
Please note that this is a 24 hour clock. For example,
2pm is shown as 14:00.
Auto
symbol
Cookpot
symbol
A
U
T
O
TIMER
Programming
controls
Time
setting
In case of loss of power, all the settings (time of
day, set programme or programme in operation),
will be cancelled. When the power is restored,
the numbers on the display will flash, and the timer has to be reset.
TO SET THE TIME OF DAY
F
Press button , release the button, then turn the time
setting knob until the correct time of day is displayed.
TO SET THE MINUTE MINDER
F
Press button , release the button, then turn the setting
time knob until the duration time is displayed (maximum
23 hours, 59 minutes).
Our diagram shows the timer set for 45 minutes. After a
few seconds the time of day will show in the display.
To check the number of minutes remaining, press the
button. At the end of the timed period an alarm will
TIMER
TIMER
sound. To switch off the alarm press button .
8
Loading...