Zanussi ZA98-3W User Manual

REFRIGERATOR-
FREEZER
ZA 98/3 W
INSTRUCTION BOOKLET
2222 183-71
19
G
H
F
D
PR18
F
F
F
E
E
Printed on recycled paper
Door reversal directions
1. Disconnect from the electricity supply.
2. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing;
3. Remove the ventilation grill (D).
4. remove the bottom hinge (E) by unscrewing its three fixing screws;
5. Remove the freezer door by releasing it from the middle hinge (H).
6. Unscrew the middle hinge.
7. Remove the fridge door by releasing it from the top hinge pin (G).
8. Remove the pin then mount these on the side, after having removed the small plugs which should then be fitted on the opposite side.
9. using a 10 mm spanner, unscrew the hinge pin (E) and reassemble it on the opposite side of the hinge;
10.Refit the fridge door and replace the middle hinge to the left hand side.
11.reassemble the lower hinge (E) on the opposite side, using the screws previously removed. Slide the hole cover (F) out of the ventilation grille (D) by pushing it in the direction of the arrow and reassemble it on the opposite side;
12.reassemble the door;
13.refit the ventilation grille (D), clipping it into place;
The doors can be aligned by adjusting the middle hinge.
The middle hinge can be adjusted horizontally, after having slackened the two screws with a screwdriver.
Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
D419
3
CONTENTS
2222 183-71
Instructions for the User
Important Safety Information
2
Description of the Appliance
4
Operation
5
Before using 5
Control panel 5
Start your appliance 5
Temperature control 5
Freezing fresh food 6
Frozen food storage 6
Thawing 7
Making ice cubes 7
Cold accumulators 7
Fresh food refrigeration 6
Movable shelves 8
Positioning the door shelves 8
Drawer 8
Cool Check Guide 9
Freezing calendar 9
Hints and Tips
10
Maintenance and Cleaning
11
Internal cleaning 11
External cleaning 11
When the appliance is not in use 11
Changing the light bulb 11
Defrosting 12
Something Not Working
13
Service and Spare Parts
14
Customer Care
14
Guarantee Conditions
15
Instructions for the Installer
Technical Specification
16
Installation
17
Positioning 17
Rear Spacers 17
Electrical Connection
18
Door Reversal
19
17
INSTALLATION
Positioning
This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each climate classification:
SN +10°C to + 32°C
N +16°C to + 32°C
ST +18°C to + 38°C
T +18°C to + 43°C
It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.
You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B).
There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation.
Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers.
D200
NP00
100 mm10 mm
10 mm
A
B
Important
IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.
Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on Door reversal.
Important
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
D594
Rear spacers
In the bag with the documentation, there are two spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the screw head, then re-tighten the screws.
L
K
J
I
H
G
A
B
C D
E
F
5
OPERATION
Before using
Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water).
Do not use soap or detergent as the smell may linger. Dry thoroughly.
Control panel
ABCD E
F G
A - Alarm light - Red
B - Fast freeze light - Amber
C - Fast freeze switch
D - Pilot light - Green
E - Freezer Thermostat control knob
F - Fridge Pilot light - Green
G - Fridge Thermostat control knob
Control Panel
A. Alarm light
If the alarm light (A) illuminates, it indicates that the temperature within the freezer has reached a level where safe food storage is no longer ensured.
When the freezer is first switched on, the alarm light will stay on until the temperature has dropped to a safe level for the storage of frozen food.
B. Fast freeze light
The fast freeze light is illuminated, to show that the fast freeze function is working.
C. Fast freeze control switch
When you place fresh food in the appliance, press the fast freeze control switch.
D. Pilot light
The operation light is illuminated continuously, to show that the appliance is on.
E. Thermostat control knob
Turn the thermostat control knob clockwise to required setting.
Start your appliance
Allow the appliance to stand for 2 hours after installation.
Insert the plug into the wall socket. The pilot light (D) will illuminate to show that the appliance is on.
Turn the thermostat control (G) to a midway setting. The pilot light (F) will illuminate. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside.
To switch off the appliance turn the thermostat control to position “O” .
Temperature control
The temperature within the freezer is controlled by the thermostat situated at the top of the cabinet.
To operate the freezer proceed as follows:
Turn the thermostat control knob beyond the «O» position.
When you first start the freezer, we suggest that you turn the thermostat control to a medium setting. For easier turning of this control, use a small coin.The internal temperature of the freezer is automatically adjusted by the thermostat to ensure safe food storage.
However, if the appliance is working in unfavourable room conditions such as
- poor ventilation,
- high temperature,
15
Standard guarantee conditions
We, Zanussi, undertake that if within 12 months of the date of the purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that:
The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
The appliance has been used for normal domestic purposes only, and in accordance with the manufacturers instructions.
The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us.
All service work under this guarantee must be undertaken by a Zanussi Service Force Centre. Any appliance or defective part replaced shall become the Companys property.
This guarantee is in addition to your statutory and other legal rights.
Home visits are made between 8.30am and 5.30pm Monday to Friday. Visits may be available outside these hours in which case a premium will be charged.
Exclusions
This guarantee does not cover:
Damage or calls resulting from transportation, improper use or neglect, the replacement of any light bulbs or removable parts of glass or plastic.
Costs incurred for calls to put right an appliance which is improperly installed or calls to appliances outside the European Community (EC) or European Free Trade Area.
Appliances found to be in use within a commercial environment, plus those which are subject to rental agreements.
Products of Zanussi manufacture which are not marketed by Zanussi.
European Guarantee
If you should move to another country within Europe then your guarantee moves with you to your new home subject to the following qualifications:
The guarantee starts from the date you first purchased your product.
The guarantee is for the same period and to the same extent for labour and parts as exists in the new country of use for this brand or range of products.
This guarantee relates to you and cannot be transferred to another user.
Your new home is within the European Community (EC) or European Free Trade Area.
The product is installed and used in accordance with our instructions and is only used domestically, i.e. a normal household.
The product is installed taking into account regulations in your new country.
Before you move please contact your nearest Customer Care centre, listed below, to give them details of your new home. They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances.
France Senlis +33 (0)3 44 62 29 29
Germany Nürnberg +49 (0)800 234 7378
Italy Pordenone +39 (0)0434 39 4700
Sweden Stockholm +46 (0)8 672 53 90
UK Slough +44 (0)1753 219 897
GUARANTEE CONDITIONS
Loading...
+ 14 hidden pages