Zanussi WJS 1382 User Manual

WASHER-DRYER

WJS 1382

124976950

INSTRUCTION BOOKLET

YOUR NEW WASHER-DRYER

This new machine, which is fitted with the Jet
System, patented Zanussi, meets all modern
needs for effective treatment of laundry with low
water, energy and detergent consumption.

Further savings are achieved by washing small
loads of laundry, since water and electricity
consumption is proportional to the quantity and
type of laundry being washed.

■

The temperature selector dial will allow
you to choose the most suitable temperature
for your laundry.

■

The special wool programme with its new
delicate wash system treats your woollen
with extreme gentleness.

■

The automatic cooling of the washing
water from 95° to 60°C before draining will

prevent old drain pipes from being deformed.

■

The two drying programmes will give your
wash that soft, relaxed feel whatever the
weather.

Hints on how to save energy

By following these hints you will obtain
economical washing without damaging the
environment:

■

Whenever possible, wash the maximum load
for the selected programme, without
overloading the drum.

■

Use the prewash programme only for very
soiled laundry.

■

Measure out detergent according to the

water hardness, the degree of soiling and the
quantity of laundry being washed.

Environment protection

■

Packaging recycling

Materials marked with the symbol are
recyclable. To enable them to be recycled, they
must be placed in the appropriate collection
areas (or containers). Check with your local
authorities.

>PE<= polyethylene
>PS<= polystyrene
>PP<= polypropylene

■

Machine scrapping

When the appliance is to be scrapped, cut off
the power supply cable and make the door
closing device inoperative to avoid it becoming
a death trap for a child.

For correct disposal of the machine, contact
your local authority department which provides
for collection of urban solid refuse.

The symbols you will see on some paragraphs of this booklet have the following meaning:

Important information concerning the
safety in the use of your machine.
Disregarding this information might
lead to damages.

Information for correct use of your

i

machine and to obtain the best
performance.

Important information concerning
environment protection.

Our contribution to the protection of the
environment: we use recycled paper.

2

ENGLISH

CONTENTS

Warnings 4
Description of the appliance 5

■

Detergent dispenser drawer 5

Technical specifications 5
Installation 6

■

Transit devices 6

■

Positioning 6

■

Water inlet 7

■

Water drainage 7

■

Electrical connection 8

Use 9

■

Control panel 9

■

Controls 9

■

Programme selection 10

■

Washing and drying hints 11
Sorting the laundry 11
Temperatures 11
Before loading the laundry 11
Maximum loads 11
Removing stains 11
Detergents and additives 12
Drying 12

■

International wash code symbols 13

■

Operating sequence 14-15

■

Washing and drying programmes 16-17

Maintenance 18

■

Bodywork 18

■

Detergent dispenser drawer 18

■

Drain filter 18

■

Water inlet filter 19

■

Emergency emptying out 19

■

Frost precautions 19

Something not working? 20-21

3

WARNINGS

It is important that this instruction book be kept with the appliance for future reference. If you sell or
give the appliance away, make sure that the book is passed to the new owners so that they can
familiarise themselves with its operation and relevant warnings.
The following warnings are provided in the interests of overall safety. You must read them carefully
before installing or using the appliance.

■

General warnings

■

When unpacking the appliance, check that it
is not damaged. If in doubt, do not use it and
contact the Service Centre.

■

This appliance is designed to be used by
adults. Children must not be allowed to touch
the controls or play with the product.

■

During high temperature washing and drying
cycles the glass door becomes very hot. Do
not touch it.

■

Pets sometimes climb into washing
machines. Check the drum before each use.

Installation

■

All internal packing must be removed before
using the appliance. Serious damage may be
caused to the machine or adjacent furniture if
the protective transit devices are not removed
or are not completely removed. Refer to the
relevant paragraph in the instruction book.

■

Any electrical work required to install this
appliance must be carried out by a qualified
electrician.

■

Any plumbing work required to install this
appliance must be carried out by a qualified
plumber.

■

After having installed the machine, check that
it is not standing on its electrical supply cable.

■

If the appliance is placed on a carpeted floor,
ensure that air can circulate freely between
the adjustable feet and the floor.

Use

■

This appliance is designed for domestic use.
It must not be used for purposes other than
those for which it was designed.

■

Only wash and dry fabrics which are
designed to be machine washed and dried.
Follow the instructions on each garment
label.

■

If you use a liquid detergent with a dispenser
which has to be placed directly in the drum,
remember to remove this dispenser before
drying.

Do not overload the appliance. Follow the
instructions in the instruction book.

■

Make sure that all pockets are empty. Objects
such as coins, safety pins, pins and screws
can cause extensive damage.

■

Do not machine wash garments saturated
with petroleum, methylated spirits,
trichlorethylene, etc. If such fluids have been
used to remove stains prior to washing, wait
until they have completely evaporated from
the fabric before placing garments in the
appliance.

■

Place small items such as socks, belts, etc. in
a cloth bag or pillowcase to prevent them
getting trapped between the drum and the
tub.

■

Use only the recommended quantities of fabric
softener. An e xcessiv e amount could damage
the laundry.

■

Leave the porthole door slightly ajar when the
appliance is not in use. This preserves the
door seal and prevents the formation of
musty smells.

■

Always check that water has emptied out
before opening the door. If not, drain the
water following the instructions in the
instruction book.

■

Always unplug the appliance and shut the
water tap after use.

Service/repair

■

In the event of a fault, do not attempt to repair
the appliance yourself. Repairs carried out by
inexperienced persons may cause damage.

■

If repairs are needed, contact an authorised
service centre and ask for genuine spare
parts.

4

ENGLISH

DESCRIPTION OF THE APPLIANCE

01 Detergent dispenser drawer
02 Drying pilot light
03 Drying time selector dial
04 Spin speed reduction button
05 On/Off button
06 Temperature selector dial
07 Operating pilot light
08 Programme selector dial
09 Programme card

10 Door locked light
11 Door handle
12 Filter
13 Adjustable feet

Detergent dispenser drawer

12345678

9

10
11

12

13

Prewash
Main wash

Fabric softener

P0260

TECHNICAL SPECIFICATIONS

DIMENSIONS Height 85 cm

Width 60 cm
Depth 60 cm

WASHING DRYING

MAXIMUM LOAD Cotton 6.5 kg 3.00 kg

Synthetics 2.5 kg 2.00 kg
Delicates 2.0 kg ­Woollens 1.0 kg -

SPIN SPEED 1300 rpm max.
POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz

TOTAL POWER ABSORBED 2200 W
MINIMUM FUSE PROTECTION 10 A

WATER PRESSURE Minimum 5 N/cm

Maximum 80 N/cm

This appliance complies with the following EEC Directives:

73/23/EEC of 19/02/73 relating to low voltage
89/336/EEC of 03/05/89 relating to electromagnetic compatibility

2
2

5

INSTALLATION

Unpacking

All transit bolts and packing must be
removed before using the appliance.

You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.

1. Using a spanner, unscrew and remove the rear
right-hand bolt and lay the machine on its
back, taking care not to squash the hoses.
This can be avoided by placing one of the
corner packing pieces between the machine
and the floor.

2. Remove the polystyrene block from the bottom
of the machine and release the two plastic
bags by removing the adhesive strip.

3. Carefully remove the right-hand bag (1) then
the left-hand bag (2) by pulling them towards
the centre of the machine.

P0255

2

1

4. Set the machine upright and remove the two
remaining bolts from the back.

5. Pull out the three plastic spacers from the
holes into which the bolts were fitted.

6. Plug the open holes with the plugs which you
will find in the plastic bag containing the
instruction booklet.

Positioning

Install the machine on a flat hard floor.
Make sure that air circulation around the machine
is not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units.
Carefully level by screwing the adjustable feet in
or out. Never place cardboard, wood or similar
materials under the machine to compensate for
any unevenness in the floor.
After having levelled the machine, tighten the lock
nuts.

P0234

P0256

P0254

P0233

P0020

P0509

6

ENGLISH

Water inlet

Connect the water inlet hose to a tap with a 3/4"
thread after having inserted the small filter “A”
supplied with the machine.

The other end of the inlet hose which connects to
the machine can be turned in any direction.
Simply loosen the fitting, rotate the hose and
retighten the fitting, making sure there are no
water leaks.

The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you
will have to purchase a new, longer hose
specially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in
three ways:

Hooked over the edge of a sink using the
plastic hose guide supplied with the machine.

In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with a
piece of string or attaching it to the wall.

P0003

A

P0021

In a sink drain pipe branch. This branch must
be above the trap so that the bend is at least
60 cm above the ground.

Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter of
the drain hose.

The drain hose must not be kinked. Run it along
the floor; only the part near the drainage point
must be raised.

P0022

P0023

7