Zanussi WIJ1074 User Manual

LAVASCIUGA

LAVADORA-SECADORA MAQUINA DE LAVAR E SECAR WASHER-DRYER

WIJ 1074

LIBRETTO ISTRUZIONI

MANUAL DE USO

MANUAL DE UTILIZAÇÃO

124987993

INSTRUCTION BOOKLET

YOUR NEW WASHER-DRYER

This new washing machine, which is fitted with the Jet System, patented Zanussi, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption.

Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed.

■The temperature selector dial will allow you to choose the most suitable temperature for your laundry.

■The special wool programme with its new delicate wash system treats your woollen with extreme gentleness.

■The automatic cooling of the washing water from 95° to 60°C before draining will prevent old drain pipes from being deformed.

■The two drying programmes will give your wash that soft, relaxed feel whatever the weather.

Hints on how to save energy

By following these hints you will obtain economical washing without damaging the environment:

■Whenever possible, wash the maximum load for the selected programme, without overloading the drum.

■Use the prewash programme only for very soiled laundry.

■Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed.

■Use a “short programme” when washing lightly soiled laundry.

Environment protection

■ Packaging recycling

Materials marked with the symbol are recyclable. To enable them to be recycled, they must be placed in the appropriate collection areas (or containers). Check with your local authorities.

>PE<= polyethylene >PS<= polystyrene >PP<= polypropylene

■ Machine scrapping

When the appliance is to be scrapped, cut off the power supply cable and make the door closing device inoperative to avoid it becoming a death trap for a child.

For correct disposal of the machine, contact your local authority department which provides for collection of urban solid refuse.

The symbols you will see on some paragraphs of this booklet have the following meaning:

Important information concerning the safety in the use of your machine. Disregarding this information might lead to damages.

Information for correct use of your i machine and to obtain the best

performance.

Important information concerning environment protection.

Our contribution to the protection of the environment: we use recycled paper.

70

CONTENTS

Warnings		72	Maintenance		87
Description of the appliance		73	■	Bodywork	87
			■	Detergent dispenser drawer	87
■	Detergent dispenser drawer	73	■	Drain filter	87
Technical specifications			■	Water inlet filter	88
		73	■	Emergency emptying out	88
Installation			■	Frost precautions	88
		74
■	Transit devices	74	Something not working?		89-90
■	Positioning	75
■	Water inlet	75
■	Water drainage	75
■	Electrical connection	76
■	Building-in	76-77
Use		78
■	Control panel	78
■	Controls	78
■	Programme selection	79
■	Washing and drying hints	80
	Sorting the laundry	80
	Temperatures	80
	Before loading the laundry	80
	Maximum loads	80
	Removing stains	80
	Detergents and additives	81
	Drying	81
■	Operating sequence	82-83
■	Washing and drying programmes	84-85
■	International wash code symbols	86

71

WARNINGS

It is important that this instruction book be kept with the appliance for future reference. If you sell or give the appliance away, make sure that the book is passed to the new owners so that they can familiarise themselves with its operation and relevant warnings.

The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance.

General warnings

■When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre.

■This appliance is designed to be used by adults. Children must not be allowed to touch the controls or play with the product.

■During high temperature washing and drying cycles the glass door becomes very hot. Do not touch it.

■Pets sometimes climb into washing machines. Check the drum before each use.

Installation

■All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book.

■Any electrical work required to install this appliance must be carried out by a qualified electrician.

■Any plumbing work required to install this appliance must be carried out by a qualified plumber.

■After having installed the machine, check that it is not standing on its electrical supply cable.

■If the appliance is placed on a carpeted floor, ensure that air can circulate freely between the adjustable feet and the floor.

Use

■This appliance is designed for domestic use. It must not be used for purposes other than those for which it was designed.

■Only wash and dry fabrics which are designed to be machine washed and dried. Follow the instructions on each garment label.

■If you use a liquid detergent with a dispenser which has to be placed directly in the drum, remember to remove this dispenser before drying.

■Do not overload the appliance. Follow the instructions in the instruction book.

■Make sure that all pockets are empty. Objects such as coins, safety pins, pins and screws can cause extensive damage.

■Do not machine wash garments saturated with petroleum, methylated spirits, trichlorethylene, etc. If such fluids have been used to remove stains prior to washing, wait until they have completely evaporated from the fabric before placing garments in the appliance.

■Place small items such as socks, belts, etc. in a cloth bag or pillowcase to prevent them getting trapped between the drum and the tub.

■Use only the recommended quantities of fabric softener. An excessive amount could damage the laundry.

■Leave the porthole door slightly ajar when the appliance is not in use. This preserves the door seal and prevents the formation of musty smells.

■Always check that water has emptied out before opening the door. If not, drain the water following the instructions in the instruction book.

■Always unplug the appliance and shut the water tap after use.

Service/repair

■In the event of a fault, do not attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause damage.

■If repairs are needed, contact an authorised service centre and ask for genuine spare parts.

72

DESCRIPTION OF THE APPLIANCE

01 Detergent dispenser drawer

02 Programme card

03 Drying pilot light

04 Drying time selector dial

05 Option buttons

06 On/Off button

07 Operating pilot light

08 Temperature selector dial

09 Programme selector dial

10 Door handle

11Filter

12Adjustable feet

Detergent dispenser drawer and programme card

Prewash

Main wash

Fabric softener

Bleach

The programme card in English is supplied with the instruction booklet and can be inserted in the detergent dispenser drawer.

1		34					5 6 7 8								9

2

10

11

12

Cl

P0238

TECHNICAL SPECIFICATIONS

DIMENSIONS	Height	82 cm
	Width	60 cm
	Depth	54 cm
	WASHING		DRYING
MAXIMUM LOAD	Cotton	4.5 kg	2.25 kg
	Synthetics	2.0 kg	1.50 kg
	Delicate fabrics	2.0 kg	-
	Woollens	1.0 kg	-
SPIN SPEED		1000 rpm max.
POWER SUPPLY VOLTAGE/FREQUENCY		220-230 V/50 Hz
TOTAL POWER ABSORBED		2200 W
MINIMUM FUSE PROTECTION		10 A
WATER PRESSURE	Minimum	5 N/cm2
	Maximum	80 N/cm2
This appliance complies with the following EEC Directives:
73/23/EEC of 19/02/73 relating to low voltage
89/336/EEC of 03/05/89 relating to electromagnetic compatibility
				73

INSTALLATION

Transit devices

All transit bolts and packing must be removed before using the appliance.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

1.Using a spanner, unscrew and remove the rear right-hand bolt.

2.Lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.

3.Remove the polystyrene base and take off the bottom panel by unscrewing the central screw.

4.Carefully remove the right-hand bag.

5.Carefully slide out the other bags.

6.Re-fit the bottom panel using the 4 screws supplied with the door hinges (in the plastic bag) and the previously removed screw.

7.Set the machine upright and remove the two remaining bolts from the back.

8.Pull out the three plastic pegs from the holes into which the bolts were fitted.

9.Plug the open holes with the plugs which you will find in the plastic bag containing the instruction booklet.

P0255

P0457

P0016

P0256

P0015

P0453

P0020

74

Positioning

Install the machine on a flat hard floor. Make sure that air circulation around the

machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

P1051

Water inlet

Connect the water inlet hose to a tap with a 3/4" thread after having inserted the small filter “A” supplied with the machine.

The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.

The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.

A

P0003

P0021

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.

Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised.

P0022

P0023

75