Zanussi NH100EAX User Manual
Libretto Istruzioni
IT
2
IT
GB
Instruction Manual
Manuel d’Instructions
FR
DE
Bedienungsanleitung
Gebruiksaanwijzing
NL
18
34
50
66
CONTENTS
DESCRIBING THE COOKER HOOD .............................................................. 19
WARNINGS....................................................................................................... 22
SETTING UP..................................................................................................... 26
INSTALLATION.................................................................................................28
ELECTRICAL CONNECTION .......................................................................... 31
USE................................................................................................................... 31
MAINTENANCE................................................................................................32
18GB
DESCRIBING THE COOKER HOOD
This domestic cooker hood has been designed for the purification of contaminated air and to remove odours
in the kitchen when fixed to the wall, over a cooking appliance.
The cooker hood can be supplied to work in the
recycling mode (through the cleansing charcoal filter
and out through the grille in the canopy into the
kitchen) or can be provided with a telescopic chimney
stack.
The telescopic chimney stack allows to use the cooker
hood only in the evacuation mode, where the air is
ducted outside with the help of a duct inside the
chimney.
The telescopic chimney is available as a kit.
ALTERNATIVE CHIMNEYS ARE AVAILABLE ON REQUEST TO MEET SPECIFIC REQUIREMENTS.
THE COOKER HOOD IS AVAILABLE IN THE FOLLOWING EXECUTIONS:
Standard
• with a complete front panel A, or
Personalized
• with a particular glass front panel P, or
To be personalized
• the front is to be personalized by the customer, fitting
a panel made of wood or any other material.
The upper cover must be removed to fit the telescopic chimney stack.
Attention! Before removing the upper cover disconnect
the hood from the mains supply and unplug the
appliance.
ΑΑ
Α
ΑΑ
P
19GB
Rear view
0 1
0 1
1 2 3
A: fixing point
B: mains cable
C: wall fixing bracket
ΑΑ
Α
ΑΑ
ΒΒ
Β
ΒΒ
ΑΑ
Α
ΑΑ
C
The fixing point A of the cooker hood is to be hooked to wall bracket C which is tightly fixed to the
wall using the provided plugs.
Internal housing
D:fan housing
E:ballast for fluorescent strip lamp
F:control board
G:lamp housing
Control panel
To gain access to the concealed control panel F apply slight pressure to the front edge of the cover and the
panel will spring open, hinged at the rear.
A: lighting switch
B: fan switch
C: speeds switch
Underside view
D: metal grease filters They can be washed in hot water and mild detergent or can be cleaned in a dishwasher.
E: lamp
F: control panel
F
D
G
ΑΑ
Α
ΑΑ
ΒΒ
Β
ΒΒ
C
ΕΕ
Ε
ΕΕ
ΧΧ
Χ
ΧΧ
ΕΓΙΛ031293−0140
F
F
D
Attention! Before removing the metal grease filters
disconnect the hood from the mains supply or unplug
the appliance.
ΕΕ
Ε
ΕΕ
Rating plate
The rating plate contains all the data of the cooker hood
G: charcoal filter.
MOD 9211
.....V~ ....Hz TOT .....W
1x...... W 1x.... W MAX
G
20GB
Dimensions:
360
720
1000
1000
360 134
1414
360
720
360
905
21GB
WARNINGS
This cooker hood has been designed for the purification
of contaminated air and to remove odours in the kitchen.
ATTENTION!
This cooker hood must not be used for the purification
of air containing:
• Harmful gases
• Poisons
• Substances not to be found during normal cooking.
Before carrying out any kind of maintenance or cleaning of the cooker hood:
• Disconnect the hood from the mains supply(switch in position 0)
• Unplug from the socket.
• Connect the hood to the mains supply via a double
pole switch which has 3mm minimum clearance
between the contacts.
3 mm
22GB
Loading...