Zanker ZKK9410, ZKK9408, ZKK9412 User Manual

Kühlschränke ZANKER ZKK 9408 Réfrigérateurs ZKK 9410 Koelkasten ZKK 9412 Refrigerators
Gebrauchsanweisung Mode d’emploi Gebruiksaanwijzing Instruction booklet
2222 245-11
GB
WARNINGS
GB
It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance.
General Safety
This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product.
It is dangerous to alter the specifications or
Under no circumstances should you attempt to repair the appliance yourself.
Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts.
modify this product in any way.
Care must be taken to ensure that the appliance does not stand on the electrical supply cable.
Before any cleaning or maintenance work is
This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized
technicians. carried out, be sure to switch off and unplug the appliance.
This appliance is heavy. Care should be taken when moving it.
Ice lollies can cause frost burns if consumed straight from the appliance.
Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages.
The appliance must not be located close to radiators or gas cookers.
Avoid prolonged exposure of the appliance to direct sunlight.
There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided.
For freezers only (except built-in models): an ideal location is the cellar or basement.
Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances, unless they are approved for this purpose by the manufacturer.
Use
The domestic refrigerators and freezers are
designed to be used specifically for the storage of
edible foodstuffs only.
Frozen food must not be re-frozen once it has been
thawed out.
Manufacturers’storage recommendations should
be strictly adhered to. Refer to relevant
instructions.
The inner lining of the appliance consists of
channels through which the refrigerant passes. If
these should be punctured this would damage the
appliance beyond repair and cause food loss.
DO NOT USE SHARP INSTRUMENTS to
scrape off frost or ice. Frost may be removed by
using the scraper provided. Under no
circumstances should solid ice be forced off the
liner. Solid ice should be allowed to thaw when
defrosting the appliance. See defrost instructions.
Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance.
Service / Repair
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used.
Do not use a mechanical device or any artificial
means to speed up the thawing process other than
those recommended by the manufacturer.
Never use metal objects for cleaning your
appliance as it may get damaged.
Printed on recycled paper
Installation
During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction.
If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor.
There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions.
Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall.
If the appliance has been transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor.
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the symbol are recyclable.
CONTENTS
Installation 47
Positioning 47
Cleaning the interior 47
Instructions for totally built-in appliances 48
Inner door reversal 50
Electrical connection 50
Technical specification 55
Use 51
Operation 51
Temperature regulation 51
Fresh food refrigeration 51
Movable shelves 52
GB
GB
Positioning the door shelves 52
Freezing fresh food 53
Storage of frozen food 53
Thawing 54
Ice-cube production 54
Defrosting 54
Maintenance 56
Periodic cleaning 56
Periods of non-operation 56
Interior light 56
Customer service and spare parts
56
INSTALLATION
If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance.
This will prevent it from becoming a death-trap for a child.
Positioning
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN).
The class of your appliance is shown on its rating plate.
For building into kitchen units follow the special “Building-in” instructions given.
GB
GB
Important
It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations.
The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression.
This appliance complies with the following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent modifications.
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish.
Loading...
+ 9 hidden pages