Zanker ZKDW24 User Manual

Afwasautomaat - Lave-vaisselle - Geschirrspüler - Dishwasher

Gebruiksaanwijzing

(deel 1) bladzijde 2

Notice d’utilisation

(partie 1) page 11

Bedienungsanleitung

(Teil 1) Seite 23

Instruction book

(part 1) page 33

NL

F

D

GB

35

Only use salt specifically designed for use in
dishwashers.
All other types of salt not specifically designed for use in
a dishwasher, especially table salt, will damage the water
softener.
Only fill with salt just before starting one of the washing
programmes (except the Rinse and Hold programme).
This will prevent any grains of salt or salty water, which
may have been spilt, remaining on the bottom of the
machine for any period of time, which may cause
corrosion.

To fill:

1. Open the door, remove the lower basket and unscrew the

cap of the salt container by turning it anticlockwise.

2. Pour 1 litre of water inside the container (this is necessary
only before filling with salt for the first time).

3. Using the funnel provided,

pour in the salt until the
container is full.

4. Replace the cap making
sure that there is no trace
of salt on the screw
thread or on the gasket.

5. Screw on the cap tightly
turning it clockwise until it
stops with a click.

The salt container will require topping up periodically.

According to the model of dishwasher, you are reminded
of this by:

A) The salt cap has a refill indicator window in the centre.

A green float is clearly visible when there is salt inside the
container and almost disappears when the salt has finished
reminding you to add salt.

B) A salt indicator light on

the control panel will come on when the salt has finished.
The salt indicator light on the control panel can remain
illuminated for 2-6 hours after the salt has been replenished,
assuming the dishwasher remains switched on. If you are
using salts that take longer to dissolve then this can take
longer. The function of the machine is not affected.

Do not worry if water over flows from the unit when filling with
salt, this is quite normal.

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying. The
dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.

Rinse aid can be added in one of two ways:

● If you are using dishwasher detergent that already contains

rinse aid, the detergent including the rinse aid is placed in
the detergent compartment.

- In this case the rinse aid compartment must be empty.
If in the rinse aid dispenser there is still rinse aid you
must wait until it has finished before using detergent that
contains rinse aid.

● If you are using dishwasher detergent and rinse aid

separately, the rinse aid is to be put into the rinse aid
dispenser.

- In this case the rinse aid dosage must be set in position
from 1 to 6 (see "Adjusting the dose") and the rinse aid
indicator light activated.

Filling with rinse aid

(Rinse aid dispenser type A)

1. Open the container by pressing the release button (A).

2. Fill with rinse aid exactly up to the level indicator marked

"max".

Ensure that the lid is closed after every refill.

Adjusting the dose

According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position 6 maximum dosage).

Increase the dose if there are drops of water or lime spots on
the dishes after washing.

The dose is factory set in
position 4.

Reduce it if there are sticky
whitish streaks on the dishes.

SR14

SALE

ZOUT

SALT

SALZ

SEL

SR22

BR07

BR14

BR09

36

Filling with rinse aid

(Rinse aid dispenser type B)

1. Open the container by turning the lid (A) anticlockwise.

2. Fill with rinse aid exactly up to the level indicator marked

"max".

Ensure the lid is closed after every refill.

Adjusting the dose

According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (C)
(position 1 minimum dosage, position 6 maximum dosage).

Increase the dose if there are drops of water or lime spots on
the dishes after washing.

The dose is factory set in position 5.
Reduce it if there are sticky

whitish streaks on the
dishes.

Top up with rinse aid when:

1. The indicator (B) becomes clear,

2. Only for dishwasher models with rinse aid indicator
light:

When the rinse aid indicator light on the control panel
illuminates (when the machine is switched on and the door
closed).

Clean up any rinse aid spilt during filling with an absorbent
cloth to avoid excess foaming during the next wash.

Only use branded rinse aid for dishwashers. Never fill the rinse
aid dispenser with any other substances (e.g. dishwasher
cleaning agent, liquid detergent). This would damage the
appliance.

BR01

BR13

BR11

BR03

BR02

37

Use of detergent

Only use detergents specifically designed for use in
dishwashers.

Using no more then the correct amount of detergent
contributes to reducing pollution.

Prior to the start of a wash programme. The detergent is
released during the washing phase.

Please observe the manufacturer’s dosing and storage
recommendations as stated on the detergent packaging.

Fill with detergent

(Detergent dispenser type A)

1. If the lid is closed: press release button (1).

The lid springs open.

2. Fill the detergent dispenser (2) with detergent.
The marking indicates the dosing levels:

20 = approximately 20 ml of detergent
30 = approximately 30 ml of detergent

3. All programmes with prewash need an additional detergent
dose (5 g) that must be placed in the prewash detergent
chamber (3). This detergent will take effect during the
prewash phase.

4. Close the lid and press until it locks in place.

Fill with detergent

(Detergent dispenser type B)

1. Open the dispenser by pulling the catch (A).

The lid springs open.

2. Fill the detergent dispenser with detergent.
The marking indicates the dosing levels:

Min = approximately 15 g of detergent
Max = approximately 30 g of detergent

3. Close the lid and press until it locks in place.

4. All programmes with prewash need an additional detergent

dose (5 g) that must be placed over the lid of the dispenser.
This detergent will take effect during the prewash phase.

Use of "3 in 1" combi detergent tablets

General advice

These products are tablets with combined detergent/rinse-aid
and salt functions.

1. Before using these products you should first check that the
water hardness in your supply is compatible with the use of
these products as per the detergent manufacturers (on the
product packaging).

2. These products should be strictly used according to the
detergent manufacturers instructions.

Do not place the tablets in the tub or in the cutlery
basket as this will result in poorer wash results. The
tablets should be placed in the detergent dispenser.

3. If you encounter problems when using 3 in 1 products for

the first time then please contact the detergent
manufacturers care line (the telephone number is given on
the product packaging).

Special advice

When using combination products, the rinse-aid and salt
indicators are no longer useful (please note that only some
dishwashers have these options). Select the lowest possible
setting for water hardness.

For more information please refer to the instruction manual.
If you decide to turn back to the use of the standard detergent

system we advise that you:

● Refill both the salt container and rinse aid dispenser.

● Switch the water hardness setting to the highest possible

position and run a normal washing programme without a
load.

● Readjust the water hardness setting again according to the

hardness of the water in your area.

Concentrated detergent

Based on their chemical composition, dishwasher detergents
can be split into two basic types:

- conventional, alkaline detergents with caustic components.

- low alkaline concentrated detergents with natural enzymes.

The use of 50°C washing programmes in conjunction with
concentrated detergents reduces pollution and is good for your
dishes; these wash programmes are specially matched to the
dirt-dissolving properties of the enzymes in the concentrated
detergent. For this reason 50°C wash programmes in which
concentrated detergents are used can achieve the same
results that can otherwise only be achieved using 65°C
programmes.

Detergent tablets

Detergent tablets of different brands dissolve at different
speeds. For this reason some detergent tablets cannot
develop their full cleaning power during short programmes.
Therefore please use normal programmes with prewash when
using detergent tablets.

DE19

DE22

DE17

DE02