Yazoo/Kees RBSIC050, RBSITt550, RBSIT550, RBSIT551, SBSIC050 User Manual

Safety and Operator's Manual for

MODELS:

RBSIC050
RBSIT550
RBSIT551
SBSIC050
RHON050

Professional Quality Lawn Care Equipment

since 1945

Thank you for buying a YAZOO/KEES! Before operating your new power rake, read,
understand and follow the important safety instructions and the other instructions con­tained in this manual. Lawnmowers and all power equipment, can be potentially danger­ous if used improperly. SAFETY REQUIRES GOOD JUDGEMENT, CAREFUL USE

IN ACCORDANCE WITH INSTRUCTIONS AND COMMON SENSE.

MANUAL No. 100431 REV. 07 (02/19/02)

Printed in U.S.A.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: Failure to comply with the following instructions may result in serious injury to the operator or other persons. The
owner of the machine must understand these instructions, and must allow only persons who understand these instructions
to operate the machine. Each person operating the machine must be of sound mind and body and must not be under the
influence of any substance which might impair vision, dexterity or judgment. If you have any questions about your machine
which your dealer cannot answer to your satisfaction , call or write YAZOO / KEES POWER EQUIPMENT, Beatrice, NE
68310 ( Phone [phone])

TRAINING

1. Read this manual carefully and question your dealer if
something is not clear.Should the dealer be unable or
unavailable to answer to your satisfaction, write or call our
factory. Be thoroughly familiar with the controls and proper
use of the equipment.

2. Do not put hands or feet near or under rotating parts. Keep
clear of discharge area while engine is running.

3. Stop engine when crossing gravel drives, walks, roads, or
under any condition where thrown objects might be a hazard.

2. DO NOT allow children in yard or area when machine is
operated.

3. DO NOT allow pre-teenage children to operate unit.

4. Allow only responsible teenagers with mature judgment to
operate machine and only under close supervision.

5. Keep the area clear of all persons, particularly small
children and pets.

PREPARATION

1. Never operate machine without proper guards, covers,
safety switches and devices in place and properly functioning.
Inspect to determine that these safety devices are installed
properly, are in good repair, and operate properly. If the
condition of these devices are questionable, they must be
repaired or replaced before using the machine.

2. Thoroughly inspect the area where machine is to be used
and remove all stones, sticks, wire, and other debris. Also
note the location of holes, stumps, and other possible
hazards.

3. Do not operate the machine when barefoot or wearing open
shoes.Always wear substantial footwear and long pants.

4. Fill gasoline tank before starting the engine. Use only an
approved gasoline container. Do not smoke near open gasoline
container. Do not fill gasoline tank indoors or when engine is
running. Allow engine to cool off for at least 10 minutes before
refueling. Wipe off any spilled gasoline before starting engine.
Do not run engine indoors.

4. After striking a foreign object or if machine vibrates
abnormally, stop the engine and disconnect the spark plug.
Inspect the machine for any damage and repair the damage.

5. Stop the engine whenever you leave the operating position
for any reason, including clearing debris, inspecting, or
making adjustments.

6. Rake across slopes, never up and down. Use caution
when changing direction on slopes. Do not rake very steep
slopes, or areas where stability or safety might be in doubt.

7. Do not rake water-soaked lawns. This will pull turf off the
surface. Cut tall grass before raking.

MAINTENANCE

1. Keep all nuts, bolts, and screws tight to keep mower in
safe operating condition.

2. Never store machine with gas in the tank inside a building
where fumes can reach an open flame or spark. Allow engine
to cool before storing in an enclosure.

3. To reduce fire hazard, keep machine free of grass, leaves,
or excessive grease.

4. Have your machine inspected and serviced each year by
an authorized Yazoo/ Kees dealer. Determine if any additional
devices are available which might upgrade the safety of your
machine.

5. Use only authentic Yazoo/Kees replacement parts to
insure the safety of your machine is maintained.

5. Never attempt to make a depth adjustment while engine
is running.

6. Operate only in daylight or in good artificial light.

7. Never operate machine in wet grass. Always be sure of
your footing; keep a firm hold on the handle and walk, never
run.

OPERATION

1. Do not change engine governor settings or overspeed the
engine.

WARNING

!

!

THE ENGINE EXHAUST FROM

THIS PRODUCT CONTAINS

CHEMICALS KNOWN TO THE STATE

OF CALIFORNIA TO CAUSE

CANCER, BIRTH DEFECTS OR

OTHER REPRODUCTIVE HARM

2

.

F AMILIARIZATION

Figure 1

This manual has been prepared for the operators of the
Yazoo/Kees Power Rake, Model RBSIC050 and Slicer,
Model SBSIC050. Its purpose, aside from recommending
operating instructions and routine service requirements, is to
promote safety through the use of accepted operating
practices. READ, UNDERSTAND AND FOLLOW the safety
and operating instructions herein before attempting any work
with the machine.

NOMENCLATURE

The nomenclature drawing above (Figure 1) shows the
essential parts of the Yazoo/Kees Power Rake/Slicer. It is
recommended that all operators of this equipment become
thoroughly familiar with the controls, parts and operation of
this machine before operating. Specific details involving the
engine are found in the seperate engine owner’s manual.
Study these manuals before operating and keep both handy
for future reference.

3

OPERA TING INSTRUCTIONS

BEFORE OPERATING:

Be thoroughly familiar with all controls and how to use them
before operating the Dethatcher/Slicer. Make the following
checks and perform the service as required before each start
up.

PRE-START CHECK LIST
CHECK ENGINE OIL and bring level up to full. (Refer to
engine manual for oil specifications).

CHECK AIR CLEANER and service according to instructions
in Engine Manual.

FILL FUEL TANK where fumes will be safely dissipated.
Refer to Engine Manual for fuel specifications.

CHECK DETHATCHER OR SLICER SHAFT ASSEMBLY to
make sure it is free of dirt and other debris.

CHECK EXTERNAL SURFACES and remove any dirt and
dust accumulation.

CHECK GUARDS to make sure all are in proper position and
securely tightened.

STARTING-STOPPING
Know beforehand how to stop the engine and rotation
of the DETHATCHER or SLICER shaft in preparation for
possible emergencies.

Shaft rotation is stopped by releasing the CLUTCH CONTROL
BAIL. See Figure 3.

Figure 3

OPERATE ENGINE AS FOLLOWS:
STEP 1:

The engine of the DETHATCHER/SLICER is stopped by
pulling the engine THROTTLE CONTROL to the rear to
“STOP”. See Figure 2

Move HEIGHT ADJUSTMENT LEVER to “TRANSPORT”
position. (This insures that the Shaft Assembly is clear of the
ground/pavement should accidental engagement of CLUTCH
CONTROL BAIL occur.) See Figure 4.

Figure 2 Figure 4

4