Yazoo/Kees RBSIC050, RBSITt550, RBSIT550, RBSIT551, SBSIC050 User Manual

...
4 (1)

Safety and Operator's Manual for

MODELS: RBSIC050 RBSIT550 RBSIT551 SBSIC050 RHON050

Professional Quality Lawn Care Equipment

since 1945

Thank you for buying a YAZOO/KEES! Before operating your new power rake, read, understand and follow the important safety instructions and the other instructions contained in this manual. Lawnmowers and all power equipment, can be potentially dangerous if used improperly. SAFETY REQUIRES GOOD JUDGEMENT, CAREFUL USE

IN ACCORDANCE WITH INSTRUCTIONS AND COMMON SENSE.

MANUAL No. 100431 REV. 07 (02/19/02)

Printed in U.S.A.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: Failure to comply with the following instructions may result in serious injury to the operator or other persons. The owner of the machine must understand these instructions, and must allow only persons who understand these instructions to operate the machine. Each person operating the machine must be of sound mind and body and must not be under the influence of any substance which might impair vision, dexterity or judgment. If you have any questions about your machine which your dealer cannot answer to your satisfaction , call or write YAZOO / KEES POWER EQUIPMENT, Beatrice, NE 68310 ( Phone 402-223-2391)

TRAINING

1.Read this manual carefully and question your dealer if something is not clear.Should the dealer be unable or unavailable to answer to your satisfaction, write or call our factory. Be thoroughly familiar with the controls and proper use of the equipment.

2.DO NOT allow children in yard or area when machine is operated.

3.DO NOT allow pre-teenage children to operate unit.

4.Allow only responsible teenagers with mature judgment to operate machine and only under close supervision.

5.Keep the area clear of all persons, particularly small children and pets.

PREPARATION

1.Never operate machine without proper guards, covers, safety switches and devices in place and properly functioning. Inspect to determine that these safety devices are installed properly, are in good repair, and operate properly. If the condition of these devices are questionable, they must be repaired or replaced before using the machine.

2.Thoroughly inspect the area where machine is to be used and remove all stones, sticks, wire, and other debris. Also note the location of holes, stumps, and other possible hazards.

3.Do not operate the machine when barefoot or wearing open shoes.Always wear substantial footwear and long pants.

4.Fill gasoline tank before starting the engine. Use only an approvedgasolinecontainer.Donotsmokenearopengasoline container. Do not fill gasoline tank indoors or when engine is running. Allow engine to cool off for at least 10 minutes before refueling. Wipe off any spilled gasoline before starting engine. Do not run engine indoors.

2.Do not put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

3.Stop engine when crossing gravel drives, walks, roads, or under any condition where thrown objects might be a hazard.

4.After striking a foreign object or if machine vibrates abnormally, stop the engine and disconnect the spark plug. Inspect the machine for any damage and repair the damage.

5.Stoptheenginewheneveryouleavetheoperatingposition for any reason, including clearing debris, inspecting, or making adjustments.

6.Rake across slopes, never up and down. Use caution when changing direction on slopes. Do not rake very steep slopes, or areas where stability or safety might be in doubt.

7.Do not rake water-soaked lawns. This will pull turf off the surface. Cut tall grass before raking.

MAINTENANCE

1.Keep all nuts, bolts, and screws tight to keep mower in safe operating condition.

2.Never store machine with gas in the tank inside a building where fumes can reach an open flame or spark. Allow engine to cool before storing in an enclosure.

3.To reduce fire hazard, keep machine free of grass, leaves, or excessive grease.

4.Have your machine inspected and serviced each year by anauthorizedYazoo/Keesdealer.Determineifanyadditional devices are available which might upgrade the safety of your machine.

5.Use only authentic Yazoo/Kees replacement parts to insure the safety of your machine is maintained.

5.Never attempt to make a depth adjustment while engine is running.

6.Operate only in daylight or in good artificial light.

7.Never operate machine in wet grass. Always be sure of your footing; keep a firm hold on the handle and walk, never run.

OPERATION

 

1. Do not change engine governor settings or overspeed the

 

engine.

2

! WARNING !

THE ENGINE EXHAUST FROM

THIS PRODUCT CONTAINS

CHEMICALS KNOWN TO THE STATE

OF CALIFORNIA TO CAUSE

CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.

Yazoo/Kees RBSIC050, RBSITt550, RBSIT550, RBSIT551, SBSIC050 User Manual

FAMILIARIZATION

Figure 1

NOMENCLATURE

This manual has been prepared for the operators of the Yazoo/Kees Power Rake, Model RBSIC050 and Slicer, Model SBSIC050. Its purpose, aside from recommending operating instructions and routine service requirements, is to promote safety through the use of accepted operating practices. READ, UNDERSTAND AND FOLLOW the safety and operating instructions herein before attempting any work with the machine.

The nomenclature drawing above (Figure 1) shows the essential parts of the Yazoo/Kees Power Rake/Slicer. It is recommended that all operators of this equipment become thoroughly familiar with the controls, parts and operation of this machine before operating. Specific details involving the engine are found in the seperate engine owner’s manual. Study these manuals before operating and keep both handy for future reference.

3

OPERATING INSTRUCTIONS

BEFORE OPERATING:

Be thoroughly familiar with all controls and how to use them before operating the Dethatcher/Slicer. Make the following checks and perform the service as required before each start up.

PRE-START CHECK LIST

CHECK ENGINE OIL and bring level up to full. (Refer to engine manual for oil specifications).

CHECKAIRCLEANERandserviceaccordingto instructions in Engine Manual.

FILL FUEL TANK where fumes will be safely dissipated. Refer to Engine Manual for fuel specifications.

CHECKDETHATCHERORSLICERSHAFTASSEMBLY to make sure it is free of dirt and other debris.

CHECK EXTERNAL SURFACES and remove any dirt and dust accumulation.

CHECK GUARDS to make sure all are in proper position and securely tightened.

STARTING-STOPPING

Know beforehand how to stop the engine and rotation of the DETHATCHER or SLICER shaft in preparation for possible emergencies.

The engine of the DETHATCHER/SLICER is stopped by pulling the engine THROTTLE CONTROL to the rear to “STOP”. See Figure 2

ShaftrotationisstoppedbyreleasingtheCLUTCHCONTROL

BAIL. See Figure 3.

Figure 3

OPERATE ENGINE AS FOLLOWS:

STEP 1:

Move HEIGHT ADJUSTMENT LEVER to “TRANSPORT” position. (This insures that the Shaft Assembly is clear of the ground/pavementshouldaccidentalengagementofCLUTCH CONTROL BAIL occur.) See Figure 4.

Figure 2

Figure 4

4

Loading...
+ 7 hidden pages