Yamaha Audio NS-C300 User Manual

English
CENTER
+
CENTER
+
NS-C300
OWNER’S MANUAL
Thank you for selecting this YAMAHA NS-C300 speaker system.

PRECAUTIONS

Read these precautions carefully before using your speaker.
Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier to be driven into “clipping”. Otherwise the speaker may be damaged.
When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be taken never to exceed the speaker’s maximum input.
To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity.

PLACING THE SPEAKER

Speaker System
Do not place the speaker where it is liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance.
Placing the speaker on the same shelf or rack as the turntable can result in feedback.
When positioning the speaker, be sure to leave some space between the speaker and the wall or other hard surface.
Secure placement or installation is the owner’s responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of the speaker.
GT

CONNECTIONS TO YOUR AMPLIFIER

This speaker system is capable of standard connections and bi-wiring connections. Before making connections, make sure that the amplifier is switched off.
<Standard Connections>
Leave the short bars in place when connecting.
Short bar
Tighten
Loosen
Center speaker
+
<Bi-Wiring Connections>
Remove the short bars before connecting.
Woofer terminals
Tweeter terminals
+
Center speaker
Place the center speaker on the floor under the TV or inside the TV rack so that it is stabilized. The center speaker should be set in alignment with the center of the TV screen. The positioning of the center speaker is important, because it controls the whole sound quality of a multi channel system. Set up the center speaker on the basis of your listening position by following the owner’s manual supplied with your amplifier.
Notes
Do not place the center speaker on top of the TV. If placed, the speaker may fall and possibly cause damage or personal injury.
Though this speaker is magnetically shielded, there may be some influence on the TV picture depending on the type of TV or the placement of the speaker. In such a case, place the speaker away from the TV so that there is no influence on the TV picture.

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four points, and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inside surface of the cover with the four corresponding holes on the speaker and push gently.
Note When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools.
Main R
Main L
Subwoofer
NS-C300
Surround L
Surround R

SPECIFICATIONS

Type .......................... 2-way 3-speaker bass reflex speaker system
(Magnetically-shielded type)
Speaker Unit ...................................... 16 cm (6.5”) cone woofer x 2
3 cm (1”) dome tweeter
Nominal Impedance ............................................................. 6 ohms
Frequency Response ...............................................45 Hz – 35 kHz
Nominal Input Power .............................................................. 140 W
Maximum Input Power ........................................................... 400 W
Sensitivity ................................................................ 91 dB/2.83 V/m
Crossover Frequency .............................................................. 3 kHz
Dimensions (WxHxD) ....................................... 540 x 212 x 290 mm
(21.3” x 8.3” x 11.4 ”)
Weight ................................................................. 12.4 kg (27.4 lbs.)
Specifications subject to change without notice due to product improvements.
Care should be taken not to exceed the input power values noted above.
Amplifier or
Receiver
Connections
Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of your amplifier with the speaker cables.
Connect the (+) terminals on both the amplifier and the speaker using one side of the cable. Connect the (–) terminals on both components using the other side of the cable.
Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, –). If this speaker is connected with reversed polarity, the sound will be unnatural and lack bass.
Procedure:
Loosen the terminal knob.
Remove approx. 10 mm (3/8”) insulation from the speaker
cable and insert the bare wire end properly into the terminal hole. Tighten the knob.
Test the security of the connections by tugging lightly on the
cable at the terminal.
Note Do not let the bare speaker wires touch each other as this could damage the speaker and/or the amplifier.
Amplifier or
Receiver
Bi-Wiring Connections
This speaker system is capable of bi-wiring connections. To connect the speaker to the output terminals of the amplifier, two pairs of cables for each of woofer and tweeter are used instead of standard connections. This type of connection decreases the modulation distortion caused by electric resistance of the cables and driving current of the speakers. Consequently, purer sound quality can be expected.
To utilize bi-wiring connections, remove the short bars from the terminals first, and then connect the woofer and tweeter to the amplifier separately using two pairs of cables.
Note For bi-wiring connections, use the same type of cable for both the woofer and tweeter, making sure to match the polarity.
Printed in Malaysia
V404310
documentation manual, user maintenance, brochure, user reference, pdf manual
This file has been downloaded from:
User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes..
Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide,
manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product,
Loading...