Yamaha Audio NS-10MMTS User Manual

G

English

OWNER’S MANUAL

NS-10MMTS

Thank you for selecting this YAMAHA NS-10MMTS speaker system.

PRECAUTIONS

Read this before using the speakers.

To assure the finest performance, please read this manual

●

carefully. Keep it in a safe place for future reference.

●

Install the speakers in a cool, dry, clean place – away from
windows, heat sources, sources of excessive vibration,
dust, moisture and cold. Avoid sources of humming
(transformers, motors). To prevent fire or electrical shock,
do not expose the speakers to rain or water.

● To prevent the enclosure from warping or discoloring, do
not place the speakers where they will be exposed to
direct sunlight or excessive humidity.

● Do not place the following objects on the speakers:
Glass, china, etc.

If glass etc. falls by vibrations and breaks, it may cause
personal injury.

A burning candle etc.

If the candle falls by vibrations, it may cause fire and
personal injury.

A vessel with water in it

If the vessel falls by vibrations and water spills, it may
cause damage to the speakers, and/or you may get an
electric shock.

● Do not place the speakers where foreign objects such as
water drips might fall. It might cause a fire, damage to
the speakers, and/or personal injury.

● Do not place the speakers where they are liable to be
knocked over or struck by falling objects. Stable
placement will also ensure better sound performance.

Speaker System

● Placing the speakers on the same shelf or rack as the
turntable can result in feedback.

● Never put a hand or a foreign object into the port located
on the rear of the speaker as this might cause personal
injury and/or damage to the speaker.

● When moving the speaker, do not hold the port as it
might cause personal injury and/or damage to the
speaker.

● Any time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speakers may be damaged.

●

When using an amplifier with a rated output power higher
than the nominal input power of the speakers, care should
be taken never to exceed the speakers’ maximum input.

●

Do not attempt to clean the speakers with chemical solvents
as this might damage the finish. Use a clean, dry cloth.

● Do not attempt to modify or fix the speakers. Contact
qualified YAMAHA service personnel when any service
is needed. The cabinet should never be opened for any
reasons.

● Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of speakers.

ACCESSORIES

Check that the following items are included.

Speaker cable (10m) x 1 Mounting bracket x 1 Screw x 2 Pad x 2

E-1

PLACING THE SPEAKER

60 mm

Place the speaker precisely between the rear speakers as
shown in the figure below.

Main R

Center

Main L

Rear L

Subwoofer

Rear R

NS-10MMTS

■ To mount the speaker on a wall by using
the provided mounting bracket

1 Attach the bracket to the rear of the speaker by using the

provided screws. Remove the provided pads from the
backing sheet and put them at the lower corners of the
speaker.

2 Fasten screws into a firm wall or wall support as shown

in the figure, and hang the holes of the mounting
bracket on the protruding screws.
* Make sure that the screws are securely caught by the

narrow parts of the holes.

Tapping screw (3.5–4 mm)
(Available at the hardware
store)

Min.
20 mm

3 mm

40 mm

Wall/ wall
support

You can also use the screw holes on the bottom of the
speaker for installing the speaker on commericially
available speaker stand (if you do not use the provided
mounting bracket.)

A screw with a diameter of 4 mm can be
used.
(Hole depth : 10 mm)

E-2

Mounting bracket

Screw

Pad

WARNING

● This speaker weighs 1.5 kg (3 lbs. 5 oz.). Do not
mount it on thin plywood or a wall with soft surface
material. If mounted, the screws may come out of the
flimsy surface and the speaker may fall. This
damages the speaker or causes personal injury.

● Do not install the speaker to a wall with nails,
adhesives, or any other unstable hardware. Long­term use and vibrations may cause it to fall.

● To avoid accidents resulting from tripping over loose
speaker cable, fix it to the wall.

● This speaker features a magnetically shielded design,
but there is still a chance that placing it too close to a
TV set might impair picture color. Should this
happen, move the speaker away from the TV set.