Yamaha PM1D V1.62 User Manual

Thank you for purchasing the CS1D.

About PM1D System Software V1.62

PM1D system software V1.62 contains the following changes from V1.60.

Data compatibility

●

Data (scenes, libraries, SETUP, etc.) created on sys­tem software V1.62 cannot be loaded into a system
that is running system software V1.60 or earlier. How­ever, data created on system software V1.60 or ear­lier can be loaded into a system that is running sys­tem software V1.62.

Supplementary explanations

●

Panel display of unit names

When you turn on the UNIT NAME button, the short
name of the input channel is now displayed without
change for 2TR IN, TB, and EFF RTN (which are not
Units).

●

Auto-naming function for input channels

Even if you did not input the highlighted “U” char­acter in the short name field, the port (UNIT) was
displayed if all four characters are spaces. In V1.62,
this will not be displayed unless you input the high­lighted “U” characters.

●

RECALL PARAMETER operation in Selective
Recall

When you use Selective Recall to recall a scene whose
RECALL PARAMETER is on, the title was not re­called. In V1.62, the title will also be recalled.

●

GPI screen display

In the GPI OUT settings, the GPI OUT status (L/H)
and POLARITY (low/high) were displayed with the
opposite polarity from the actual state. In V1.62 these
are displayed with the correct polarity. The displayed
polarity is the opposite of previous versions, but data
created in V1.60 and earlier can still be used without
change.

Please note when upgrading to V1.62

●

Upgrading from V1.50 or V1.60

You must upgrade the CS1D, DSP1D, AI8, and AO8.
You do not need to upgrade the DIO8.

●

Upgrading from a version earlier than V1.50

You must upgrade all units; CS1D, DSP1D, AI8, AO8,
and DIO8.