Yamaha LP3, LP3E User Manual

LP-3 Assembly Instructions

Do not hold the LP-3 in the shaded areas, to avoid getting your fingers caught.

Hand

Danger

Bottom of the keyboard

Hand

HandHand

Danger

Slide the keyboard from rear to front as your place it on the stand to align the bolt holes.

CAUTION

• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below.

• Assembly should be carried out by at least two persons.

• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.

• Be sure to tighten up all screws upon completing assembly of each unit.

• To disassemble, reverse the assembly sequence given below.

• If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws.

Assembly procedure

1 You will need a Phillips screwdriver to assemble the

stand.

2 Open the box and remove all parts. Make sure that all

of the parts are included.

Screw set (VS64540) (A) Long screws (6 x 30 mm)

(6 x 16 mm)

(D) Caps(B) Short screws

(E) Knob bolts (6 x 40 mm)

4 Attach the braces.

1 Attach the braces to the center of the upper beam using

the short screws (B). Do not tighten the screws yet.

(B)

Correct tightenning

(A) (A)

Insufficient tightenning

2 Attach the stays to the side panels using the remaining

long screws (A). Again, do not tighten the screws yet.

3 Tighten the screws when all four are in place.

5 Set the attachments.

Note: Fix them using small screws (C).

Attachments

Small screws (C)

6 pcs. 2 pcs. 4 pcs. 4 pcs. 4 pcs.

Attachments

4 pcs.

Right side panel

Upper beam

Braces 2 pcs.

(identical)

Left side panel

3 Attach the upper beam and cap (D).

Notes: Tighten four long screws (A) loosely at first, then do

them hardly to set each screw in place correctly. When inserting the screws, turn them in loosely at first, then tighten them after making sure the upper beam is positioned correctly.

1 Secure the upper beam

with long screws (A).

2 Attach the caps (D).

Correct tightenning

Insufficient tightenning

6 Attach the keyboard to the stand.

1 After making sure that the keyboard and the stand are

both facing in the same direction, place the keyboard on the stand so that the holes of the stand are aligned with the holes in the bottom of the keyboard.

Note: Be careful not to let your finger get caught between the

stand and the keyboard.

2 Secure the keyboard using the knob bolts (E). Note: Do not tighten the bolts until all four bolts are in place.

M.D.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation