ELECTRIC
ACOUSTIC GUITAR
Owner’s Manual
Thank you for choosing a Yamaha electric-acoustic guitar.
In order to make the most of the advanced features and
performance provided by your guitar, please read this
manual carefully before using the instrument.
PRECAUTIONS
The output jack is an EIAJ-standard 1/4" phone jack. Be sure to use
an appropriate connection cable.
The built-in preamplifier is automatically turned on when a plug is
inserted into the output jack. When not using the instrument, or
when playing it without amplification, be sure to remove the plug
from the output jack so that the preamplifier power is turned off.
Always set the VOLUME control to “0” when plugging in or
unplugging the connection cable.
The battery check indicator (BAT.) will light briefly when a plug is
inserted or removed from the output jack. This is normal and does
not indicate a malfunction.
Be sure to remove the battery if the instrument will not be used for
an extended period of time in order to prevent possible damage due
to battery leakage.
Control Section
Bar Sensor
Model
System
Pickup
Pre-amplifier
Controls
Output jack
Output impedance
Includes power switch function
Power supply
Battery life
Accessories
Battery Holder
Output Jack (with power switch function)
SPECIFICATIONS
Monaural 1 Way
33 (FG) 33 (APX) 34 (APX) 34 (LW)
Piezo Pickup (Bridge)
VOLUME , MUTE , 3 BAND-EQ. , AMF
Combination end pin/power switch
1 kΩ
9V DC, S-006P (6F22) dry cell battery
Approx. 500 hours
1 hexagonal wrench
BATTERY REPLACEMENT
Be sure to replace the battery as soon as possible when the battery
check indicator lights in order to avoid reduced sound quality.
* Be sure to remove the battery if the instrument will not be used
for an extended period of time in order to prevent possible
damage due to battery leakage.
q Press the catch on the battery holder in
the direction indicated by the arrow in the
illustration in order to unlock it.
Catch
e Remove the old battery from the battery
case, and insert the new battery making
sure that the (+) and (–) terminals of the
battery are positioned as shown in the
illustration. Use only a DC9V, S-006P
(6F22) or equivalent battery.
DC9V
S-006P (6F22)
w Slide out the battery case.
Battery case
r Slide the battery case back
into the battery holder and
press firmly so that the
battery case locks into
place.
THE CONTROLS
EQUALIZER Controls
LOW : Boosts or cuts the level of the
low frequencies.
MID : Boosts or cuts the level of the
middle frequencies.
The AMF control adjusts the
center frequency of the band
affected by this control.
HIGH : Boosts or cuts the level of the
high frequencies.
MUTE Switch
When this switch is set to
ON (>), the instrument is
muted (e.g. no sound
signal is output).
AMF Control
Sets the center frequency of
the band of frequencies
affected by the MID equalizer
control. The range is from 600
Hz to 3 kHz. Please note that
this control has no effect when
the MID equalizer control is
set to its center (“0”) position.
BAT. (Battery Check)
Indicator
This indicator will light when
the battery needs to be
replaced.
Please replace the battery
as soon as possible when
the BAT. indicator lights.
VOLUME Control
Adjusts the overall output
volume level.