Yale YD-01-CON-NOMOD-SN Instruction manual

g

There are many types of Nightlatches, so please start from installation step

W

W

Turn the key 90

Turn the key 90

you open with your key only in the

s

TTUT

ali

t

s

be

latch is

t

T

y t

y

you open with your key only in th

your product may be dierent

TTT

T

Living

The functions and design of this product can be changed

Front Body

Battery Pack

Y3 Chrome

Nightlatch

Box(Option)

Screws

•

Batteries

•

•

Keyless Connected

Installation Guide

The smarter way to protect your home

•

YES , I have bought the complete package to install them onto my door.

➞ Please start from installation step

Can you open with your key in both directions? Please go to step

ON THE RIGHT PAGE

Cut Connecting Bar

Inside Outside

*

18mm

Cut with pliers to ensure a clean cut.

Place the electronic keypad in the hole on the outside of the door.
Measure the connecting bar with the provided template, then mark at 18mm and cut. If
neccessary, use a hacksaw to shorten the at connecting bar so it projects 18mm beyond the
surface of the door.
* If you are retrotting with your existing Nightlatch, please place your existing cylinder onto the

door side and mark and cut the connect
(Please refer to the ‘*’ marked image above)

Warning: The projection of the connecting bar is important to ensure the lock works correctly.
If you are tting with Y3 Nightlatch, it should not be shorter than 18mm.
If you are retrofting, please make sure you do not cut the tail bar shorter than the existing tail bar.

ing bar at the same length with your cylinder.

Door Template

ø20mm

ø32mm

Mount External Keypad and Mounting Plate

Use the template provided to
choose correct screw length
according to your door thickness.

Door Thickness

Fix with the cylinder retaining screws rst that you chose.
Make sure the front keypad is aligned before xing the
screws tightly. Now x the mounting plate onto the door.

Secure Battery Pack

Fit rst

Secure Lock Case

Staple Fitting

Connect the cable
to the battery pack

Make sure battery back
is square with the door

Screw into boss Fix screw to completely

Place Lock Case and Chisel

*

Feed the cable through the slot and then, being careful
not to overlap it, zig-zag any excess cable
behind the battery pack.

secure battery pack.

* If you have used a handing plate on STEP 1-(L) or 1-(R),

please turn the follower to the end position according to
your direction before xing the lock case.

Insert Batteries and Close the Cover

①

Check Points after Installation

Make sure to leave the door open when registering your PIN because you may accidentally lock

Ⓐ

the door while trying to register or change your PIN code.

Touch the keypad with your palm to wake up the keypad.

Ⓑ

Enter a PIN code 123456 and enter * button or touch the keypad with your palm to open the door.

Ⓒ

Turn the knob handle several times to retract the latch bolt.

Ⓓ

The knob handle will not retract the latch bolt after few seconds.

Ⓔ

PLEASE NOTE: Remember to change your master code after installation.

Chisel required

if you have diculty locating the bar into the slot in
the lock case, enter the master code 123456
followed by * to unlock the lock, this will engage the
bar and make it easier to locate.

To avoid any possibility of being locked out, do not close the door
until a PIN code has been successfully registered to allow access back in.