Xyron 850, 1200 User Manual

The Xyron 850 / Xyron 1200 is designed to be used with one of
the following replacement cartridges:

SL/DL: Double- and single sided lamination.
LAT: Front lamination with adhesive transfer on the reverse.
AT: Single - sided adhesive transfer.

Please follow the attached directions carefully.

Important Notice :
Your Xyron 850 / Xyron 1200 system is designed to permanently
attach a clear film or adhesive to the front and/or back of any
substrate that is run through the machine. The lamination film and
adhesive are not designed to be removed without substantial
damage to the laminated substrate. This process is NOT
recommended for any precious or single source documents.

User's Guide

Xyron Adhesive Application &

Laminating System

XYRON

®

850

XYRON

®

1200

Parts and Functions

Document Feed Tray

Used to guide document into dispenser. Leading
edge of document slides in between tray and
paddle during insertion. Align to right for A3/A4
documents, to the left for letter documents.

Document Feed
Paddle

Helps ensure
wrinkle-free output
by providing slight
back-tension on
document.

Roller
Springs

Provide spring
force on rollers.
Remove
springs to
remove rollers
and cut-blade.

Cut Blade

Slides to the left and right to cut output
material after it exits dispenser. Also
can be used to trim excess material
from leading edge of document.

Setting Up

Remove the Xyron System and Document Feed Tray from the packaging. The System is shipped with a sample
supply cartridge already installed. Install the feed tray by inserting it horizontally into the cartridge opening by the
grooves in the left and right dispenser side plates as shown below. When correctly
installed, the tray will rest horizontally.

Lower groove in
dispenser side plates

Upper groove
in dispenser
side plates

Basic operation

Step 1 - Insert and align document on feed tray.
Extend the document completely into the cartridge
opening. Align to the left for letter size documents,
to the right for A3/A4 documents.

Document
Feed Tray
Assembly

Cartridge
(reference)

Step 2 - Gently guide the document forward while
turning the handle clockwise.

Step 3 - Trim to desired length using the cut blade
at the roller exit. Apply pressure down on the
orange blade holder and slide to the left or right.

Replaceable
Supply Cartridge

Holds various lengths and
combinations of film and
adhesive depending upon
application.

Handle

Used to advance
cartridge supplies
when rotated
clockwise. Also,
feeds document
through dispenser.

Document
Output

Location where
document exits
dispenser when
handle is rotated
clockwise.

GB