Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed
toprovide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
•This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
•This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
2
REGULATORY INFORMATION
X-Micro WLAN 11b mini USB Adapter must be installed and used in strict accordance
with the manufacturer’s instructions. This device complies with the following radio
frequency and safety standards.
USA - Federal Communications Commission (FCC)
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause undesired operation.
Europe - R&TTE Directive
This device complies with the specifications listed below
• ETS 300-826 General EMC requirements for Radio equipment.
• ETS 300-328 Technical requirements for Radio equipment.
• EN60950 Safety Requirements for Radio equipment
The channel identifiers, channel center frequencies, and regulatory domains of each
22-MHz-wide channel are shown in following Table.
COUNTRY CHANNELS
Spain
France
France
Italy
UK
Netherlands
Germany
Austria
Belgium
Switzerland
Luxemburg
Russia
Ireland
Portugal
Norway
Denmark
Finland
Iceland
Greece
Lichtenstein
Sweden
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2454 MHz 1-8 < 100 mW EIRP < 100 mW EIRP
2454-2483.5 MHz9-13 < 100 mW EIRP < 10 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 <10 mW EIRP <10 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
2400-2483.5 MHz1-13 < 100 mW EIRP < 100 mW EIRP
MAX. OUT POWER
INDOOR OUTDOOR
3
Table of Contents
1 Introduction………………………………………... 5
2
3
4
Wireless LAN basics……………………………… 6
Windows Installation……………………………… 7
Install Driver/Utility………………………………..
3.1
Configuration Utility………………………………………….
3.2
3.2.1 Configured at “Windows XP configuration”……..
8
10
10
3.2.2 Configured at “SiS advanced configuration”…….
Technical Specifications of X-Micro WLAN 11b mini
11
15
USB Adapter
…………………………………………
Product names mentioned herein may be trademarks and/or registered trademarks of their respective companies.
FAQ………………………………………………… 16
Glossary…………………………………………… 17
4
1. Introduction
Thank you for purchasing X-Micro WLAN 11b mini USB Adapter. You are
about to install a networking system that is not only fast and powerful, but
also easy to set up and simple to maintain. In a short time you and those in
your network will be able to share a local printer and files, access the
Internet, and roam about the office wire-free.
Using radio frequency (RF) technology, WLANs transmit and receive data
over the air, minimizing the need for wired connections. Thus, WLANs
combine data connectivity with user mobility, and, through simplified
configuration, enable movable LANs.
This wireless networking solution has been designed for both large and
small businesses, and it is scalable so that you can easily add more users
and new network features as your business grows.
This manual will assist you in the installing X-Micro WLAN 11b mini USB
Adapter.
5
2. Wireless LAN basics
Wireless LAN network defined by IEEE 802.11b standard committee could be
configured as:
• Ad Hoc wireless LAN, or
• Infrastructure wireless LAN.
Ad Hoc network is a group of notebooks with wireless LAN PC card called a
BSS (Basic Service Set). These notebooks use their wireless LAN PC cards to
communicate with each other, and notebooks cannot connect to the Internet.
STA 1
STA 2
STA 3
Figure 2-1 Ad Hoc wireless network
The most obvious differentiation between Infrastructure wireless network and
Ad Hoc wireless network is that the notebooks in Infrastructure wireless
network can make use of the resource in the Internet through Access Point.
Access Point
STA 1
STA 2
STA 3
Figure 2-2 Infrastructure wireless network
Internet
To set up your notebook’s network as the type of “Ad Hoc” or “Infrastructure”
wireless network depends completely on your requirement. Generally, if your
network environment has an Access Point, we recommend that you set it as
“Infrastructure” to connect to the Internet.
6
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.