Zynq UltraScale+ MPSoC
Power Supply and
Power Cables
Ethernet
and USB
Cables
ZCU104
Evaluation
Board
USB
Camera
Send Feedback
ZCU104 Evaluation Kit
Quick Start Guide
This ZCU104 Evaluation Kit contains all the hardware, tools, and IP required to evaluate and develop your Zynq®
UltraScale+™ MPSoC design. The ZCU104 reVISION package provides out-of-box SDSoC™ development
environment software flow with OpenCV libraries, machine learning framework, and live sensor support.
Use this quick start guide to set up and configure the board, run the built-in self-test (BIST), install the Xilinx tools,
and redeem the license voucher. The guide also provides a link to additional design resources including reference
designs, schematics and user guides.
ZCU104 Evaluation Kit
X-Ref Target - Figure 1-1
For more information, visit www.xilinx.com/zcu104.
on
Built-In Self-Test (BIST) Instructions
Boot Mode Mode Pins [0:3]
QSPI32
1234
0100
DONE
LED
Power
Good
LEDs
SW4 SW3
Send Feedback
ZCU104 Evaluation Kit
STEP 1: Set Configuration Switches
Set mode switch SW6 to QSPI32.
Note: For this DIP switch, in relation to the arrow, moving the switch
toward the label ON is a 0. DIP switch labels 1 through 4 are equivalent to
MODE pins 0 through 3. Set DIP switches labeled 1 to 4 to ON, OFF, ON,
ON.
STEP 2: Connect Power
Plug the power supply into a power outlet with one of the included power
cords.
Connect the 6-pin power supply plug to J52.
Turn on the board power with the SW1 slide switch.
If the two rows of Power Good LEDs glow green, the power system is good.
VADJ (DS8) will not be on.
If the DONE LED (DS32) circled here glows green, the Zynq UltraScale+ device
has configured successfully.
STEP 3: Initiate Configuration
The built-in self-test (BIST) starts shortly after power on.
Note: Pressing the POR_B (SW4) or the SRST_B (SW3) button causes the
DONE LED to go out, the device to configure again, and the BIST to
restart.
The PL GPIO LEDs flash on and off several times at the start of the BIST.
2
www.xilinx.com
Loading...