XIGMATEK LD963 User Manual

Accessories

INSTALLATION GUIDE

STEP 6

Position the clips over the mounting holes of the motherboard, and place the cooler onto the CPU. Use the wrench and NUTS to fasten the clips to the motherboard. Connect the 4-pin connector of fan to the CPU fan’s male connector on the motherboard.

1234

56 78

AMD INSTALLATION

STEP 1

Remove the original supplied bracket from the motherboard.

Clip for Intel X 2Clip for AMD X 2 PUWrench X1 Screw-A FOR CLIP

Thermal grease X 1Screw-B for Clip X4 Standoff X 4 NUT for clip X 2

(AM3+/AM3/AM2+/AM2/FM1/2)

STEP 2

Remove the AMD clips from the supplied accessories. Note the proper mounting positions for AM2/AM3 and FM1/2 sockets.

AM2 AM3 FM1/2

STEP 3

Remove the standoffs from the accessories. Fasten the standoffs with screw-B through the fastener holes of the AMD clips.

INTEL INSTALLATION

( 775/1155/1156/1366 )

STEP 1

Remove the Intel clips from the supplied accessories. Note the proper mounting positions for LGA775, LGA 1155/1156 and LGA 1366.

STEP 3

Remove the blister and sticker from the bottom of the cooler. Fasten the clips to the cooler (using screw-A).

STEP 2

Remove the standoffs from the supplied accessores. Fasten the standoffs with screw-B through the fastener holes of the Intel clips as shown below. Ensure you are using the correct position for the LGA socket of your Intel motherboard.

STEP 4

Apply a thin layer of thermal grease evenly to the top of CPU.

STEP 4

Remove the blister and sticker from the bottom of the cooler. Fasten the clips to the cooler (using screw-A).

STEP 5

Apply a thin layer of thermal grease evenly to the top of the CPU.

STEP 5

Position the clips over the mounting holes of the motherboard, and place the cooler onto the CPU. Use the supplied wrench and mounting NUTS to fasten the clips to the motherboard. Connect the 4-pin connector of fan to the CPU fan’s male connector on the motherboard.

http://www.xigmatek.com

E-mail: support@xigmatek.com

sales@xigmatek.com

•