
Connect the HDMI
Cable to TV
Connect to CRT TV
Micro USB
AV Cable
HDMI Cable Wireless Network
Ethernet
Power
Router/Switcher
HDMIEthernet Cable
100-240 VAC / 50-60Hz
Power Cable

Connect to TV
MiBox exports both HDMI and AV Signals.
Recomment HDMI for better TV experience
Connect to Network
MiBox Box support ethernet and wireless network.
For ethernet connection please connect the ethernet cable to the
MiBox 1st;for wireless network can be setup after power up the mibox.
Startup
MiBox will startup automatically after plugin the power cable.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.