Xerox C424 User Manual

WorkCentre® C2424 Copier-Printer

User Safety

Your system and the recommended supplies have been designed and tested to meet strict safety requirements. Attention to the following information will ensure the continued safe operation of your system.

Electrical Safety

■ Use the power cord supplied with your system.

■ Plug the power cord directly into a properly grounded electrical outlet. If you do not know

if an outlet is grounded, ask an electrician to check the outlet.

■ Do not use a ground adapter plug to connect the system to an electrical outlet that does not

have a ground connection terminal.

■ Do not use an extension cord or power strip.

Warning

Avoid the potential of electrical shock by ensuring that the system is properly grounded. Electrical products may be hazardous if misused.

■ Do not place the system in an area where people might step on the power cord.

■ Do not place objects on the power cord.

■ Do not block the ventilation openings. These openings are provided to prevent overheating

of the system.

■ Do not drop paper clips or staples into the system.

Warning

Do not push objects into slots or openings on the system. Making contact with a voltage point or shorting out a part could result in fire or electrical shock.

If you notice noises or odors that are not associated with your normal system operation:

1. Turn off the system immediately

2. Disconnect the power cord from the electrical outlet

3. Call an authorized service representative to correct the problem.

A-1

The power cord is attached to the system as a plug-in device on the side of the system. If it is necessary to disconnect all electrical power from the system, disconnect the power cord from the electrical outlet.

Warning

Do not remove the covers or guards that are fastened with screws unless you are installing optional equipment and are specifically instructed to do so. Power should be OFF when performing these installations. Disconnect the power cord when removing covers and guards for installing optional equipment. Except for user-installable options, there are no parts that you can maintain or service behind these covers.

The following are hazards to your safety:

■ The power cord is damaged or frayed.

■ Liquid is spilled into the system.

■ The system is exposed to water.

If any of these conditions occur:

1. Turn off the system immediately.

2. Disconnect the power cord from the electrical outlet.

3. Call an authorized service representative.

Maintenance Safety

■ Do not attempt any maintenance procedure that is not specifically described in the

documentation supplied with your system.

■ Do not use aerosol cleaners. The use of supplies that are not approved may cause poor

performance and could create a hazardous condition.

■ Do not burn any consumables or routine maintenance items. For information on Xerox

supplies recycling programs, go to www.xerox.com/gwa

Operational Safety

Your system and supplies were designed and tested to meet strict safety requirements. These include safety agency examination, approval, and compliance with established environmental standards.

Your attention to the following safety guidelines helps to ensure the continued, safe operation of your system.

System Supplies

■ Use the supplies specifically designed for your system. The use of unsuitable materials

may cause poor performance and a possible safety hazard.

WorkCentre® C2424 Copier-Printer

A-2

+ 4 hidden pages