
INSTALLATION INSTRUCTIONS
RMZPR
RACK MOUNT ADAPTER FOR THE ZPR68-10
STATUS
1
2
3
4
5
6
ZPR68
SIX ZONE EIGHT SOURCE REMOTE PREAMP
Fig. 1 The RMZPR, Front View
The RMZPR provides a convenient means for mounting the ZPR68-10 Six Zone Eight Source Remote
Preamp into a standard 19 inch rack. It incorporates six STATUS LED's that indicate zone ON/OFF
condition. The black anodized panel is a standard 8.75 inch increment height and is 3/16" thick. Install the
panel as follows:
1. Mount the ZPR68-10 to the rear of the RMZPR. Refer to Fig. 2 below. Use the hardware that comes
with the ZPR68-10 and the RMZPR.
2. Plug the 10-lead connector of the ribbon cable into the mating 10-pin connector on the ZPR68-10.
Be sure to orient the connector so that the red stripe on the cable is positioned as shown in
Fig. 2!
NOTE: The LED's will not work with the ZPR68-00.
3. Mount the completed assembly into a 19" rack using the rack panel cup washers and screws supplied.
See Fig. 2 on next page.
Amplifiers & Preamplifiers
1

ZPR68-10
ZPR68-10
SIX ZONE EIGHT SOURCE REMOTE PREAMP
COMMON IR LEVEL
12345678
HI
LO
1 2 3 4 5 6 7 8
IR CONFIRM
12345678
VIDEO
COM
PORT
L
AUDIO
POWER
R
CO
G
POWER
SUPPLY
COMMON IR INDICATOR
COMMON IR OUTPUTS
SOURCE INPUTS
SOURCE INPUTS
STATUS
VIDEO
AUDIO
+12V
GND
IR IN
L
R
Fig. 2 The RMZPR with a ZPR68-10 Mounted to Rear Surface
ZONE CONTROL - IR INPUTS
ZONE IR OUTPUTS
123456
ZONE OUTPUTS
ZONE OUTPUTS
Mount the ZPR68-10 to the 4 studs on the rear of the RMZPR
using hardware included with the ZPR68-10 and the RMZPR
RMZPR RACK MOUNT ADAPTER (rear view)
Red Stripe
10-lead
ribbon
cable
10-lead female
connector.
Plug into mating
10-pin connector
on ZPR68-10.
Be sure to orient
the cable with
the red stripe
as shown!
PCB for
the 6 LED's
Red
Stripe
2
2-22-01
Rev.B
RMZPR