X10 WS467 User Manual
(
Wall Dimmer Set Up and Operating Instructions Model WS467
WS467
Black BlueBlack
(T o Live
or lamp)
Black
To lamp,
or Live)
The WS467 W all Dimmer Module is designed to control incandescent only lights with a rating of between 40W and
500W . Lights rated below 40W might flicker or operate erratically . The WS467 replaces a switch that controls and
indoor or outdoor ceiling light. A push-button is provided for local on/off control.
WARNING: W all Dimmer Modules must not be used to contr ol appliances, or low voltage lamps, or
fluorescent lamps.
Installing the W all Dimmer Module:
• Disconnect the power at the circuit breaker panel.
• Remove wall plate and unscrew the existing switch from its box.
• Remove the two wires from your old switch and connect them to the two wires on the WS467 using the wire nuts
provided. Make sure no bare whiskers of wire are protruding, use insulating tape to cover wire nuts if necessary .
• Screw the switch into its wall box (don’t replace the wall plate yet).
Setting up and operating the W all Dimmer Module:
• Set the House Code dial to the same letter (A thru P) that you set on your X10 controller(s).
• Set the Unit Code dial to an unused code (1 - 16) which can be controlled from any X10 controller.
• Set the power on-off slide switch (under the push button) to the ON (center) position. Turn this switch OFF (left)
when changing a light bulb.
• Replace the wall plate.
• Turn the power back on at the circuit breaker panel.
• Press the push button to turn the module on and off.
• Y ou can turn the module on and off and dim and brighten it remotely from X10 Controllers.
LIMITED 1-YEAR WARRANTY X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10
products to be free from defective material and workmanship for a period of one (1) year from the original date of
purchase at retail. X10 agrees to repair or replace, at it’s sole discretion, a defective X10 product if returned to X10
within the warranty period and with proof of purchase.
If service is required under this warranty:
Call 1-800-442-5065, visit www.x10.com, or e-mail sales@x10.com.
X10.com, a division of X10 Wireless T echnology, Inc. http://www.x10.com/support
WS467-11/02
Loading...