X10 VK74A Quick Setup Guide
Model VK74A
SCA N
SweepCenter
Norma l
A
C
E
GIK
M
O
.
.
.
.
..
.
.
Ninja™ System Quick Setup Guide
Before you read the owner’s manual for the Ninja system it is recommended that you
follow the steps below to give the system a quick try. Later you can read the owner’s
manual to see how to connect the camera’s cord inside the top of the Ninja so you only
need one power supply.
Attach camera to top of
!
Ninja with screws provided.
#
Pip
Model XM10A
or XM13A*
"
* IMPORT ANT! Do not interchange power
supplies. Model XM14A must be used only for the
Ninja Pan ‘n Tilt base.
Now connect the Receiver to your TV
● Connect the Video Receiver to its power supply and plug
the power supply into an AC outlet near your TV .
● Connect the Receiver to your TV using the RCA cable supplied.
● Set the switch on the side of the Video Receiver to ON.
● Turn your TV on and select V ideo mode. The Ninja’s power supply powers up in
the on state when you first plug it in, so you will now see a picture on your TV .
● Point the “pip” on the Camera’ s antenna and the “squares” on the Receiver’ s
antenna towards each other for the best reception.
● If you experience interference, try setting the Camera and Receiver to a different
letter channel (A, B, C, or D) - use the same letter on each (see instructions
included with them for more information).
Model XM14A*
Plug camera into power
supply included with it, and
plug power supply into an
AC outlet.
Plug Ninja into power
supply included with it, and
plug power supply into an
AC outlet.
Squares
C2
C1
CAMERA
C4
Now try it out!
C3
P2
P1
POSITION
P3
P4
● Insert 4 AAA alkaline batteries (not included) in the Remote Control.
● Press the blue buttons at the top of the remote to pan the camera left and right,
and tilt it up and down.
Program
For more information or help setting up your system,
please visit www .x10.com/support
Wireless T echnology, Inc.
Loading...