X10 VK54A User Manual
Video Sender
AA
A
AA
UDIOUDIO
UDIO
UDIOUDIO
/V/V
/V
/V/V
IDEOIDEO
IDEO
IDEOIDEO
E E
XTENDERXTENDER
XTENDER
E
XTENDERXTENDER
E E
S S
YY
STEMSTEM
Y
STEM
S
YY
STEMSTEM
S S
OWNER'S MANUAL
MODEL VK54A
(INCLUDES VT32A S ENDER & VR30A RECEIVER)
INTRODUCTION
CONTENTS
The VT32A Video Transmitter works with the VR30A Video Receiver.
Both are included in the VK54A Wireless Video Sender kit. You connect
the VT32A Sender to your DBS receiver, VCR, Cable Box, etc., and
connect the VR30A Receiver to the TV which can be in another room, up
to 100 feet away. The Video Sender converts the Audio and Video signals
from your DBS receiver, VCR, Cable Box, etc., into wireless Radio
Frequency (RF) signals and transmits them (even through walls) to the
Video Receiver unit. The Video Receiver converts the signals back to A/V
signals which are fed through a cable to your TV's COAX or A/V input
jacks.
When used with X10 universal remotes your Video Sender also lets you
operate some brands of DBS while watching it in another room. By
purchasing an optional Powermid IR Extender System (Model PM5900)
you can control other A/V products such as VCRs, Cable Boxes, etc. while
watching a TV in another room.
FCC CAUTION
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and used
properly, that is, in strict accordance with the manufacturers instructions, it may cause
interference to radio and television reception. It has been type tested and found to comply
with the limits for remote control devices in accordance with the specifications in Sub-Parts
B and C of Part 15 of FCC Rules, which are designed to provide reasonable protection
against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, which can be determined by unplugging the
equipment, try to correct the interference by one or more of the following measures.
• Reorient the antenna of the radio/TV experiencing the interference.
• Relocate the equipment with respect to the radio/TV.
• Move the equipment away from the radio/TV.
• Plug the equipment into an outlet on a different electrical circuit from the radio/TV
experiencing the interference.
• If necessary, consult your local Dealer for additional suggestions.
NOTE: Modifications to this product will void the user's authority to operate this
equipment.
CONTROLS AND C ONNECTIONS ...............................................4
V
IDEO SENDER ..................................................................4
V
IDEO RECEIVER ...............................................................5
C
ONNECTING UP ....................................................................6
H
OOKING UP THE VIDEO SENDER .........................................6
H
OOKING UP THE VIDEO RECEIVER ......................................8
F YOU WANT TO USE YOUR VIDEO SENDER TO TRANSMIT
I
YOUR STEREO SYSTEM ONLY........................................9
FROM
R
EMOTE EXTENDER FEATURE ................................................10
T
ROUBLESHOOTING ..............................................................10
TV Channel Switch
2.4 GHz Channel
Switch
2.4 GHz
Channel
SENDER
(TOP VIEW)
Switch
ECEIVER
R
(BOTTOM VIEW)
22
2
22
33
3
33
CONTROLS AND CONNECTIONS
VIDEO SENDER
IR Extender
Jack
Antenna for
IR Extender
Feature
2.4 GHz Channel
Switch
A/V Input
Jacks
2.4 GHz Video
Antenna
ON-OFF
Switch
(on side)
Power Supply
Jack
VIDEO RECEIVER
TV Output
Connector
TV Channel
Switch
(on bottom)
2.4 GHz Video
A/V Input
Jacks
Antenna
ON-OFF
Switch
(on side)
Power Supply
Jack
2.4 GHz Channel
Switch
(on bottom)
44
4
44
55
5
55
Loading...