X10 SW10E DATASHEET
Wall Mounted
Motor Drive Switch
230VAC - 50 HZ -
6A LOAD RATING
Key features
• Control using "BRIGHT" for up and "DIM"
for down by RF remotes
• Replaces the normal wall switch for the
shutter, curtain or sunshade motor control
and responds to X10 signals.
• Works with any X10 controller and RF
remote controller.
Product number : SW10E
Benefits
The X10 wall mounted motor drive switch is a receiver
module that is controlled by any X10 controller. It can
be used for curtains, sun shades and shutters. The
most common application is shutter control.
The unit controls the position of a shutter or a blind
either in response to X10 signals received on the
powerline or manually from pushbuttons on the front
face of the unit.
If the serial control message is in STANDARD X10
format, the unit can be:
- Fully opened in response to "unit code" "On"
- Fully closed in response to "unit code" "Off"
- Opens in response to "unit code" "Bright"
- Closes in response to "unit code" "Dim"
Each "Dim" or "Bright" message will move the motor
by 4% of the opening. If the message is in
PROFESSIONAL X10 format, then any position can be
possible with a single message.
• Can also be used as an ordinary switch.
Technical data
• Supply voltage: 230V +10% -15% 50 Hz
• Power consumption: < 1W
• Making capacity: 6 A - 250 VAC (motors)
• EMC emission: according to EN 50081-1
• EMC immunity: according to EN 50082-1
• Electrical safety: according to EN 60950
and EN 60065
• Signal sensitivity:
50 mVpp min. at 120 kHz
• Input impedance: ≥ 180 Ohms (L - N) at
120 kHz
• Connections: screw type terminals for
phase, neutral, motor forward and motor
reverse
• Ambient temperature:
- 10° C to + 50° C (operation)
- 20° C to + 70° C (storage)
• Available in Schuko form
The unit is currently supplied with cover plate Jung
CD 500 and mounting frame.
Typical applications
Make your house look "lived-in" when you are away
with presence simulation of your shutters or curtains.
When going out, one button controls all shutters.
Loading...