X10 PH10 DATASHEET

Key Features

• Alarm output: 95 Decibel.

• Plugs into any 220V ~ 50Hz outlet.

Benefits

The Powerhorn PH10E remote siren is a remote

controlled siren with a piercing 95 decibel sound

output. It receives signals over existing house wiring

and responds to the "All Lights On/All Units Off"

flashing sequence from any X10 Home Security

System, or the SM10E Burglar Alarm Interface.

The Powerhorn adds to any security system the ability

to trigger a remote siren without the need for any

special wiring. You just plug it in! Any security system

which uses the SM10E, to flash lights when the alarms

trips, can trigger the Powerhorn.

When used with an X10 security system or the

SM10E, the Powerhorn will trip a few seconds after

the alarm trips and continues to sound until 4 seconds

after the alarm stops or is disarmed.

You can also trip the Powerhorn from any other X10

controller, which is useful in panic situations. It can

be set to respond to any of the 256 X10 codes

available (16 House codes x 16 Unit Codes). You

simply press All Lights On followed by All Units Off

repeatedly or press the unit code corresponding to

the number set on the PH10E then press On, then

Off repeatedly. This will trigger the Powerhorn after

about two ON-OFF sequences and will continue as

long as you keep repeating the sequence. The siren

will shut off about 4 seconds after the last key is

pressed.

Powerhorn

Remote

Power Siren

Product number : PH10E

Technical data

• Supply voltage: 230V ±10% 50 Hz

• Supply current : < 20 mA capacitive

• Sound output: 95 dB

• EMC emission: according to EN 50081-1

• EMC immunity: according to EN 50082-1

• Electrical safety: according to EN 60950
and EN 60065

• Signal sensitivity:
15 mVpp min;

50 mVpp max at 120 kHz

• Input impedance:
> 55W (L-N) at 120 kHz

• Ambient temperature:

- 10° C to + 50° C (operation)

- 20° C to + 70° C (storage)

• Dimensions:
53 x 123 x 33 mm

(width x height x depth)