Wuxi Hutec Technology HJCSJ82 User Manual

User Manual

1. Input voltage:AC 120V±20%

2. Output current: max AC6.3A(resistive load)

3. Terminals

a. P1—120 VAC.

b. P2— AC out , connected to the Motor

4. Operating

a. When it is connected to the AC power supply, the controller begins

working with a green LED lighting.

b. Open the Apps on , set the phone wifi connection according to the

instruction and let the controller be connected to the network. Then the

green LED turns in flashing. At this time, the value of temperature and

humidity on the Apps can be adjusted.

c. While automatic mode is selected, if the controller detects a value

of temperature and humidity higher than the setting, the relay on the

controller begins working, and output AC120V to drive the motor. A red

LED turns on.

If the value becomes lower than the setting, the relay stops working.

The motor will stop and the red LED turns off.

d. While manual mode is selected, changing the ON/OFF setting of

Apps will start the motor at once.

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving an　 tenna.

Increase the separation between the equipment and receiver.　

Connect the equipment into an outlet on a circuit different from that to which the 　

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.　

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.