USER MANUAL
ITEM NO.: 0920
6+
RobotZombie™ Apocolypse!
Congratulations on your purchase of RobotZombie™!
At one time just a working robot, RobotZombie™ was infected with a mysterious Zombie virus,
and is now on the prowl to spread the infection.
Inside you will nd instructions on how to not only battle this mechanical menace in Zombie
Infection mode, but also how to take direct control and access his movements and functions!
Contents
X1 RobotZombie™
X1 Zombie Blaster
RobotZombie™
X3 Foam Darts
X1 Instruction Manual
Zombie Blaster
3 Foam Darts
02
Battery Detail
BATTERY REQUIREMENTS:
Your robot is powered by 4 x “AA” size Alkaline batteries
(2 batteries in each foot - not included).
Your zombie blaster is powered by 3 x “AAA” batteries (not included).
BATTERY INSTALLATION:
• Be sure the robot power button is in the OFF position before installing or
changing batteries.
• Remove the battery covers with a Phillips/crosshead screwdriver as shown
(not included).
• Install recommended batteries as shown, making sure battery polarity is correct
(batteries not included).
• Replace battery doors and carefully tighten all screws.
1.5V “AAA”
LR03 / UM4
1.5V “AAA”
LR03 / UM4
1.5V “AAA”
1.5V“AA”
LR6 / UM3
1.5V“AA”
LR6 / UM3
1.5V“AA”
LR6 / UM3
1.5V“AA”
LR6 / UM3
LR03 / UM4
RobotZombie™
: Base of Feet Zombie Blaster: Side View
IMPORTANT BATTERY INFORMATION:
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, dierent types of batteries [standard
(Carbon-Zinc), Alkaline or rechargeable] or rechargeable batteries of dierent capacities
• Remove rechargeable batteries from the toy before recharging them
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
re
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not to be short-circuited
• Remove exhausted batteries from the toy
• Batteries should be replaced by adults
• Remove batteries if the toy is not going to be played with for some time
LOW BATTERY INDICATORS:
When RobotZombie™ ’s batteries grow weak, your RobotZombie™ will move and walk very slowly
When this occurs, power robot OFF and replace all batteries.
When the Zombie Blaster’s batteries grow weak, RobotZombie™ will no longer respond to the
commands. When this occurs, replace all batteries
• Robot will just stop when battery power gets VERY low. Power o and replace all batteries.
NOTE
• Some lighting or sunlight can interfere with infra-red signals.
03
RobotZombie™ Overview
Cranium
Plate
Exploding
Arms
Light Up
LED Eyes
Exploding
Arms
Right
Chestplate
04
Left
Chestplate
Infra-Red
Receiver
Front View
Cranium
Plate
Cranium
Plate
Speaker
Infra-Red
Receiver
Removable
Arms
Removable
Arms
ON/OFF
Switch
Back View
05
Zombie Blaster Overview
Basic Controls
Discover hidden sounds by trying
different button sequences and
combinations!
Forward
Turn Left
Back
SFX1
Command RobotZombie™
to burp, laugh maniacally,
or groan!
Hold for extended effect!
TOP View
CAUTION:
Do NOT aim at eyes or face.
TO AVOID INJURY:
Use only darts designed for this
product. Do not modify darts or
Zombie Blaster.
Turn Right
Boost
SFX2
Command
RobotZombie™ to
shuf e around!
Zombie Blaster - Side View
Barrel
Note: Swivel the barrel to load the
next foam dart to the chamber.
Infra-Red
Transmitter
Trigger
NOTE
06
• Do NOT store Zombie Blaster cocked and ready to re.
• Be sure to upload darts before storing away.
Compression
Handle
Assembly Instructions
Tilt head forward
Click in arms
1. Load Foam Darts, pull back compression handle
1 1
2
2. Press the trigger to fire
Close Cranium Plates
2
Hit him in the forehead to blast
open the cranium plates!
Blast off arms by hitting
the chestplates!
07
Advanced controls
Boost
Boost RobotZombie™’s power core, increasing his speed!
Supercharge
Supercharge RobotZombie™’s memory circuits,
causing him to activate sounds and memories from
his past!
lurch
RobotZombie™ will suddenly lurch forward,
de ecting incoming re!
// /+
+
+
NOTE
08
Infection mode
Allow the Zombie virus to take over,
activating RobotZombie™’s Infection mode!
Hold down button for...?
• Standby Mode: After 3 minutes of inactivity, RobotZombie™’s
lights will shut down and he will enter Standby Mode. To exit
Standby Mode, press any button on the Zombie Blaster.
• Power Down Mode: After 5 minutes of inactivity,
RobotZombie™
activate the chestplate or cranium cover, or switch the power
OFF then ON again.
will power down. To exit Power Down Mode,
Zombie Infection Gameplay
To play Zombie Infection, rst make sure that RobotZombie™ is fully assembled.
Then, press quickly on the Zombie Blaster. RobotZombie™ will growl and his
eyes will start to blink as he moves around, searching for
uninfected machinery and humans.
To defeat him in time, you must blast off both his arms by hitting the two chest
plates rst, then hit him in the head to blast open his head plate before your time
runs out.
If you win, RobotZombie™ will be deactivated. If your time runs out before
deactivating him, you become RobotZombie™’s latest victim. Whether you win or
lose, you can still reassemble RobotZombie™ and take direct control or play Zombie
Infection again!
09
CONTACT INFORMATION
To learn more about RobotZombie™ and related products, go to www.wowwee.com
Register your product at www.wowwee.com/register
If you have any questions that are not answered in this user manual, refer to www.wowwee.com/support
The equipment that you have purchased has required the extraction and use of natural resources for its manufacturing. It may
contain substances that are hazardous to health and the environment. In order to prevent the release of these substances into
the environment and to reduce the pressure on natural resources, we encourage you to use appropriate return systems. These
systems will ensure that most of the materials in your equipment are properly reused or recycled at the end of its operational life.
The crossed-bin symbol invites to use these systems. For further information on collection, reuse and recycling systems, pleas
contact your regional waste management administration.
This symbol is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the
correct method of disposal.
010
e
COLLECT THESE AND OTHER
WOWWEE PRODUCTS!
RobotZombie™ Mini
RobotZombie™
Roboraptor™ Robosapien X™ RoboMe™
011
Manufactured and distributed by © 2013 WowWee Group Limited.
Product names, designations, and logos are trademarks or registered trademarks of WowWee Group Limited. All rights reserved.
Customer service: www.wowwee.com/support
Customer support is only available in English and French.
We recommend that you retain our address for future reference. Product and colors may vary. Packaging printed in China.
WARNING! This product is not suitable for children under 3 years because of small parts — choking hazard.
This user manual should be kept as it contains important information.
Made in China.
CAUTION
compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
Installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
radio frequency interference, or sudden power surge/interruption. The user is encouraged to reset the equipment should any
of these occur.
cations not expressly approved by the party responsible for
culty and/or memory loss when subjected to any electrostatic discharge,
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected
• Consult the dealer or experienced radio/TV technician for help
This Device complies with Part 15 pf the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accpet any interference received,
including interference that may cause undesired operation.
For these purposes, the party responsible is:
WowWee USA Inc.
875 Prospect Suite #202, La Jolla, CA 92037
WowWee Group Limited
Energy Plaza, 301A-C
92 Granville Road
T.S.T. East, Hong Kong
WowWee Canada Inc.
3500 de Maisonneuve West
Suite 800
Montreal, QC H3Z 3C1 Canada
0920US01WCO
Loading...