Grill Module Installation Guide
GRILL MODULE
Contents
3 Grill Module
4 Specications
6 Installation
7 Troubleshooting
Features and specications are subject to change at any
time without notice. Visit wolfappliance.com/specs for the
most up-to-date information.
Important Note
To ensure this product is installed and operated as safely
and efciently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specied.
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
2 | Wolf Customer Care 800.222.7820
GRILL MODULE
Product Information
Important product information including the model and
serial number are listed on the product rating plate. The
rating plate is located on the bottom of the module. Refer
to the illustration below.
If service is necessary, contact Wolf factory certied service
with the model and serial number. For the name of the
nearest Wolf factory certied service or for questions
regarding the installation, visit the contact & support section
of our website, wolfappliance.com or call Wolf customer
care at 800-222-7820.
RATING
PLATE
Rating plate location.
wolfappliance.com | 3
SPECIFICATIONS
Installation Requirements
A minimum 2" (51) is required from the bottom of the grill
module to combustible materials. Refer to the illustration on
the following page for additional minimum clearances.
The use of downdraft ventilation is not compatible with the
grill module.
WARNING
Failure to locate the module without proper clearances
will result in a re hazard.
Electrical
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustration
on the following page. A separate circuit, servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
Performance may be compromised if the electrical supply is
less than 240 volts.
When multiple cooktops or modules are installed side by
side, each unit must have its own separate recommended
electrical circuit.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded 3-wire, 240/208 VAC, 50/60 Hz
Service 15 amp dedicated circuit
Conduit exible 4'
(1.2 m)
4 | Wolf Customer Care 800.222.7820
RATING
PLATE
Rating plate location.
SPECIFICATIONS
Grill Module
INSTALLATION
21/2" (64) min
13"
(330)
18"
(457)
14"
(356)
COUNTERTOP CUT-OUT
30"
(762)
7"
(178)
E
191/2"
(495)
21/2" (64) min
VIEW
TE: Shaded area above countertop indicates minimum clearance to combustible surfaces,
tible materials cannot be located within this area.
FRONT VIEW
wolfappliance.com | 5
INSTALLATION
Module Installation
Remove the module and components from the shipping
package and recycle packing materials.
1 Lower module into the opening. Center module with
the front parallel to the edge of the countertop. Using
a pencil, outline the rear edge of the module on the
countertop.
2 Remove module.
3 Apply the foam strip to the underside of the module
frame. Refer to the illustration below. Do not seal module
to the countertop.
FOAM STRIP
COUNTERTOP
CLIP
CLAMPING
BRACKET
SCREW
4 Insert module into the opening, aligning rear edge with
the pencil line. Verify module is aligned with the edge of
the countertop.
5 To attach brackets to the sides of the module, insert
clips into the side punchouts and press down. Install
clamping screws into the brackets and tighten until
screws contact the underside of the countertop. Do not
overtighten. Refer to the illustration below.
Module installation.
6 | Wolf Customer Care 800.222.7820